English
Language : 

6411 Datasheet, PDF (2/2 Pages) Pomona Electronics – Back Probe Pin
AC Output Buffered Modules
GENERAL SPECIFICATIONS
Min. Dielectric Input/Output (1 Minute)
Min. Isolation Resistance Input/Output (@ 500V)
Capacitance input to output
Temperature Range — Operating
Temperature Range — Storage
4,000 VRMS
1010 Ohms
8 pF
-40˚ C to 80˚ C
-40˚ C to 125˚ C
CURRENT DERATING CURVE
WIRING & MECHANICAL DIAGRAMS
3.5
DC LOGIC
SUPPLY
STATUS
LED
x
3
(+)
3.0
2.5
4
DC LOGIC INPUT
INV or
NON-INV
Zero
Switch
LOGIC
2.0
5
1.5
COM (-)
1.0
0
20
40
60
80
AMBIENT TEMPERATURE (ºC)
Max. Load Current vs. Temp.
BUFFERED OUTPUT MODULES
A buffered non-inverting module turns on when pin 4 is held in the
low state (logic 0), the same as standard modules driven in the sink
mode. A buffered inverting module conversely turns on when pin 4
is held high (logic 1). In the absence of an input signal and/or logic
supply (open Circuit), all models will be in the off-state.
CAPTIVE
#4-40. PHILLIPS
HEAD HOLD
DOWN SCREW
1.25
(31.7)
BOTTOM VIEW
1.00
(25.4)
1.70
(43.1)
Buffered modules may be used with standard 5 pin PB or MS
mounting boards. However, the 3.3K pull-up resistor will add to the
logic drive current of a non-inverting module and may be removed.
For an inverting module, the resistor must be removed to avoid a
false “on” command, unless a “normally closed” condition is desir-
able for use with a ground seeking (logic 0) signal source.
.25
(6.3)
5 43
2
1
.040 (1.0) DIA.
(5 PLACES)
.70
(17.8)
1.20
(30.5)
1.40
(35.5)
1.60
(40.6)
AC
OUTPUT
1
LOAD
~
2
.30
(7.6) .60
(15.2)
.100
(2.5)
.30
(7.6)
All dimensions are in inches (millimeters)
FastFax Document No. 308
081398, PAGE 2 OF 2
©1998 CRYDOM CORP Specifications subject to change without notice.
For recommended applications and more information contact:
USA: (800) 8 CRYDOM • (800) 827-9366 • (619) 715-7200 • fax (619) 715-7280
Crydom Corp, 9525 Chesapeake Drive, San Diego, CA 92123 • e-mail: sales@crydom.com
WEB SITE: http://www.crydom.com FASTFAX Product Information: (888) 267-9191
UK: (44)1202 812300 • fax (44)1202 812340 Crydom International Ltd., 85, Condor Close,
Woolsbridge Industrial Estate, Three-Legged Cross. Wimborne, Dorset, England BH21 6SU
GERMANY: (49) (0)6874 182580 • fax (49)(0)6874 182585 Crydom GmbH,
Gewerbegebiet Im Schachen, D-66687 Nunkirchen, Germany • e-mail: vertrieb@crydom.com
9002