CLY6D-FKC Datasheet, PDF (9/10 Pages) Cree, Inc – PLCC6 3 in 1 SMD LED

REFLOW SOLDERING
• The CLY6D-FKC is rated as a MSL 5a product.
• The recommended floor life out of bag is 24hrs.
• The best practices suggestion is to bake 24-hour/80ºC before use.
• The temperature profile is as below.
Melting-point
Cree PLCC6 3 in 1 SMD LED
CLY6D-FKC
Document No.: COTCO-05-0057
Rev. NO. : 13
Pre-heat
Soak
Reflow
Cooling
Time
_{U se al lSMD b esi des LP6-NP P1- 01-N1}
Use o^Sn^oly^ldw^erit⁼h ^SCⁿL⁶Y³6^-D^P-^bF³K⁷C
Average ramp-up rate = _S4_oºC_ld/_es_rmax.
Solder = Lead-free
Average ramp-up rate = 4ºC/s max
Avera_Pge_rer_ham_eap_t-u_tep_mra_pte_er=_at4_uº_rC_e/s₌m₁a₀x_{0ºC ~150ºC}
Preheat temperature = 150ºC ~200ºC
Prehe_Pat_rete_hm_ep_ae_tr_ta_imtur_ee ₌=₁1₀5₀0_sºC_m~_a2_x0_.0ºC
Prehe_Rat_at_mim_pe_-d=_o1_w2_n0s_ram_ta_ex_{= 6ºC/s max.}
Ramp-down
Peak
t^re^am^tep⁼er⁶a^ºt^Cu^/r^se^m=^a2^x30ºC
max.
Peak temperature = 250ºC max
Time within 5ºC of actual Peak Temperature = 10s max.
Time within 5ºC of actual Peak Temperature = 10s max
Durat^Dion^ura^ab^to^iovⁿe 2^a1^b7^oº^vC^eis¹6⁸0³s^ºCma^isx ^{80s max.}
Preheat time = 100s max.
Ramp-down rate = 6ºC/s max.
Peak temperature = 250ºC max.
Time within 5ºC of actual Peak Temperature = 10s max.
Duration above 217ºC is 80s max.
Only use LP6-NPP1-01-N1 ^[13]
Solder = Low Lead-free
Average ramp-up rate = 3ºC/s max.
Preheat temperature = 130ºC ~170ºC
Preheat time = 120s max.
Ramp-down rate = 6ºC/s max.
Peak temperature = 213ºC max.
Time within 3ºC of actual Peak Temperature = 25s max.
Duration above 200ºC is 40s max.
Recommended solder pad design for heat dissipation (2-pin SMD LED):
7.0
Copyright © 2010 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo and XLamp are registered trademarks
2.6 ^{oCfopCyrerieg,hItn©c. 2015 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the Cree logo are registered trademarks of Cree, Inc.}
9