CN13990 Datasheet, PDF (6/75 Pages) Cree, Inc – Saga series

35
C/C
4
3.2
50
LED position
Bottom view
Scale: 2:1
3
Top view
Scale: 2:1
Lens
NOTES:
Maximum recommended tightening torque for SAGA-FRAME is 0,4Nm
The final IP-rating is dependant of the whole luminaire design
and some solutions may need additional potting or covering
elements in order to achieve desired level of protection. To
achieve fully sealed protection LEDiL recommends to fasten
SAGA holder directly on the heatsink.
H
G
Holder
2
Isometric view
Scale: 1:1
Front view
Scale: 2:1
Tolerances if not otherwise shown
According to DIN ISO 2768-1
Linear measures: class V
Please note that due to the elasticity of
products made of silicone actual measured
values may vary, and therefore typical
tolerance values may not be applied.
THIRD ANGLE PROJECTION:
This drawing is the property
of LEDiL Oy. It may not be
reproduced, copied or
communicated without a written
agreement with LEDiL Oy."
Ledil Oy
Salorankatu 10
FIN 24240 SALO
Finland
DRAWING TITLE
CN13990_SAGA-HB-IP-WHT
SIZE PART NUMBER
A3
CN13990
SCALE 2:1 WEIGHT
-
SHEET
1
1/1
B
A