LP379PBG1-C0G-03 Datasheet, PDF (4/5 Pages) Cree, Inc – P4 LED

Mechanical Dimensions ^{Document No. SPE/LP379PBG1-C0G-03}
Rev. No.
02
All dimensions are in mm. Tolerance is ±0.25 mm unless otherwise noted.
An epoxy meniscus mayDeximtenednasboioutn1.D5 mramwdionwgn the leads.
Burr around bottom of epoxy may be 0.5 mm max.
maximum
Unit
ting
0
mA
00
mA
5
V
32
mW
+100
°C
+100
°C
°C for 3 sec Max.
e base o_Nf t_oh_te_ee_spoxy bulb)
RoHS Compliance
The levels of environmentally sensitive, persistent biologically toxic (PBT), persistent organic pollutants (POP), or
s ( Ta = 25°C) otherwise restricted materials in this product are below the maximum concentration values (also referred to as the
threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Direc-
tive 2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS), as amended through April 21, 2006.
Conditi^Vo^isn^{ion Advisory C}M^laiⁱn^m.
Typ.
Max.
Unit
Users should be cautioned not to stare at the light of this LED product. The bright light can damage the eye.
F ^{= 30mA}
---
3.6
4.4
V
V = 5V --- --- 100 PA ^{Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the}
R
Cree logo are registered trademarks of Cree, Inc.

CLD-CT117.000
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps