LP377PBG1-60G-03 Datasheet, PDF (4/5 Pages) Cree, Inc – P4 LED

Mechanical Dimensions _{Document No. SPE/LP377PBG1-60G-03}
All dimensions are in mm. Tolerance i^Rs ±^e0^v.^.25^Nm^om^. unless oth⁰e²rwise noted.
An epoxy meniscus may extend about 1.5 mm down the leads.
Dimension Drawing
Burr around bottom of epoxy may be 0.5 mm max.
maximum
Unit
ating
30
mA
00
mA
5
V
32
mW
~ +100
°C
~ +100
°C
0°C for 3 sec Max.
Notes
e base of the epoxy bulb)
RoHS Compliance
The levels of environmentally sensitive, persistent biologically toxic (PBT), persistent organic pollutants (POP), or
otherwise restricted materials in this product are below the maximum concentration values (also referred to as the
cs ( Ta = 25°C) threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Direc-
tive 2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS), as amended through April 21, 2006.
Vision Advisory Claim
Condit_Uio_sen_{rs should be c}M_aui_tn_io._{ned not to stare}T_ay_t p_th._{e light of this LE}M_D a_prx_o._{duct. The brigh}U_{t l}n_igi_ht_{t can damage the eye.}
I_F = 30mA
---
3.6
4.4
V
Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks of Cree, Inc.
V_R = 5_V
CLD-CT1^--1^-4.000
---
100
PA
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps