LO494THR4-B0G-A2 Datasheet, PDF (4/5 Pages) Cree, Inc – 4-mm Oval LED

Mechanical Dimensions
Document No. SPE/LO494THR4-B0G-A2
All dimensions are in mm. Tolerance is ^R±0^e.^v2^.5 ^Nm^om^.unless othe⁰rw²ise noted.
An epoxy meniscus may extend about 1.5 mm down the leads.
Dimension Drawing
Burr around bottom of epoxy may be 0.5 mm max.
C
e maximum
Unit
ating
50
mA
200
mA
5
V
130
mW
~ + 95
°C
~ +100
°C
60°C for 3 sec Max.
Notes
he base of the epoxy bulb)
RoHS Compliance
The levels of environmentally sensitive, persistent biologically toxic (PBT), persistent organic pollutants (POP), or
betweeotnhe1r0wmiseAreasntrdict3e0dmmAatearriaelsrienctohmis pmroednudcteadr.ePbeleloawsethecomnatxaimctuCmOcoTnCceOntration values (also referred to as the
threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Direc-
ommentidvee2d0d02ri/v9e5/cEoCnodnittihoenrse.striction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS), as amended through April 21, 2006.
ics ( Ta = 25°C)
Vision Advisory Claim
Users should be cautioned not to stare at the light of this LED product. The bright light can damage the eye.
Condition
Min.
Typ.
Max.
Unit
I = 20mA --- 2.3 2.6 V ^{Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the}
F
Cree logo are registered trademarks of Cree, Inc.

CLD-CT096.000
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps