LO494PPG4-B0G-A3 Datasheet, PDF (4/5 Pages) Cree, Inc – 4-mm Oval LED

Mechanical Dimensions
Document No. SPE/LO494PPG4-B0G-A3
All dimensions are in mm. Tolerance is ^R±0^e.2^v5^. m^Nm^o.unless othe⁰rw²ise noted.
An epoxy meniscus may extend about 1.5 mm down the leads.
Dimension Drawing
Burr around bottom of epoxy may be 0.5 mm max.
C
e maximum
Unit
Rating
25
mA
100
mA
5
V
100
mW
0 ~ +95
°C
~ +100
°C
60°C for 3 sec Max.
Notes
he base of the epoxy bulb)
RoHS Compliance
The levels of environmentally sensitive, persistent biologically toxic (PBT), persistent organic pollutants (POP), or
otherwise restricted materials in this product are below the maximum concentration values (also referred to as the
°C ics ( Ttahre=sh2o5ld limi)ts) permitted for such substances, or are used in an exempted application, in accordance with EU Direc-
tive 2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS), as amended through April 21, 2006.
Vision Advisory Claim
Condition
Min.
Typ.
Max.
Unit
Users should be cautioned not to stare at the light of this LED product. The bright light can damage the eye.
I_F = 20mA
---
3.4
4.0
V
Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks of Cree, Inc.
V_R
=
5V

---
CLD-CT095.000
---
100
PA
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps