FN15734 Datasheet, PDF (4/7 Pages) Cree, Inc – Ronda series

OPTIC/HOLDER ASSEMBLY
TYPICAL CONNECTOR ASSEMBLY (including solderless BJB
47.319.2xxx 50mm as example)
1. Place pin on the side of the lens into relative
4
hole on the holder. _B
Holder hole
DET B
Pin
2. Press the lens under clips on the holder, ensuring both
clips are fixed.
Pin
Clip
Clip
1. Assemble LED and BJB connector on
heatsink with M3 screw.
2. Attach optic by aligning hooks in the
holder with connector holes and turning
3
the optic holder clockwise until it locks.
TYPICAL CONNECTOR ASSEMBLY (including solderless IDEAL
chip lok jr 50-20 as example)
1. Assemble LED and IDEAL connector
on heatsink with M3 screw.
2. Attach optic by aligning the screw
towers in the holder with relative
2
holes in heatsink. Optionally use 2
position pins in the holder bottom as
focus element.
H
G
Tolerances if not otherwise shown
According to DIN ISO 2768-1
Linear measures:
up to 30mm class M, otherwise class C
According to DIN ISO 2768-2
Form and position: class L
THIRD ANGLE PROJECTION:
This drawing is the property
of LEDiL Oy. It may not be
reproduced, copied or
communicated without a written
agreement with LEDiL Oy.
Ledil Oy
Salorankatu 10
FIN 24240 SALO
Finland
DRAWING TITLE
RONDA-B family
SIZE PART NUMBER
A3
-
SCALE 1:1 WEIGHT
-
B
1
SHEET 3/3
A