LO494TYL4-B0G-A2 Datasheet, PDF (2/5 Pages) Cree, Inc – 4-mm Oval LED

Standard Bins for LO494TYL4-B0G-A2 (I_F = 20 mA)
Lamps are sorted to luminous intensity (I_V) and dominant wavelength ( _D) bins shown.
Orders for LO494TYL4-B0G-A2 may be filled with any or all bins contained as below.
All luminous intensity (I_V) and dominant wavelength ( _D) values shown and specified are at I_F = 20 mA.
X2
X3
X4
X5
1100 mcd
770 mcd
550 mcd
390 mcd

584 nm
587 nm
590 nm
593 nm
Dominant Wavelength ( _D)
T or above
S
R
Q
596 nm
Important Notes:
1. All ranks will be included per delivery; rank ratio will be based on the dice distribution.
2. Pb content <1000 ppm.
3. Tolerance of measurement of luminous intensity is ±15%.
4. Tolerance of measurement of dominant wavelength is ±1 nm.
5. Tolerance of measurement of V_F is ±0.05 V.
6. Packaging methods are available for selection; please refer to the “Cree LED Lamp Packaging Standard” docu-
ment.
7. Please refer to the “Cree LED Lamp Reliability Test Standards” document for reliability test conditions.
8. Please refer to the “Cree LED Lamp Soldering & Handling” document for information about how to use this LED
product safely.
Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks of Cree, Inc.

CLD-CT097.000
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps