LM6-PPG1-3B-N1 Datasheet, PDF (2/5 Pages) Cree, Inc – SMD LED

Standard Bins for LM6-PPG1-3B-N1 (I_F = 3 x 20 mA)
Lamps are sorted to luminous intensity (I_V) and chromaticity coordinates (x,y) bins shown.
Orders for LM6-PPG1-3B-N1 may be filled with any or all bins contained as below.
All luminous intensity (I_V) and chromaticity coordinates (x,y) values shown and specified are at I_F = 3 x 20 mA.
X7
X8
X9
X10
2800 mcd
2240 mcd
1800 mcd
1400 mcd
1120 mcd
520 nm
525 nm
530 nm
535 nm
Dominant Wavelength (WD)
Y1 or
above
X2
X1
W2
W1
540 nm
Important Notes:
1. All ranks will be included per delivery; rank ratio will be based on the dice distribution.
2. Tolerance of measurement of luminous intensity is ±10%.
3. Tolerance of measurement of the dominant wavelength is ±1 nm.
4. Tolerance of measurement of V_F is ±0.05 V.
5. Packaging methods are available for selection; please refer to the “Cree LED Lamp Packaging Standard” docu-
ment.
6. Please refer to the “Cree LED Lamp Reliability Test Standards” document for reliability test conditions.
7. Please refer to the “Cree LED Lamp Soldering & Handling” document for information about how to use this LED
product safely.
Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks of Cree, Inc.

CLD-CT178.000
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/ledlamps