CLX6B-FKC Datasheet, PDF (10/11 Pages) Cree, Inc – PLCC6 3 in 1 SMD LED

REFLOW SOLDERING
• The CLX6B-FKC is rated as a MSL 5a product.
• The recommended floor life out of bag is 24hrs.
• The best practices suggestion is to bake 24-hour/80ºC before use.
• The temperature profile is as below.
Melting-point
Cree PLCC6 3 in 1 SMD LED
CLX6B-FKC
Document No.: COTCO-05-0057
Rev. NO. : 13
Pre-heat
Soak
Reflow
Cooling
Time
Use all SMD besides LP6-NPP1-01-N1
_{S ol der = Sn63-Pb37Sol d er= Lead-free}
Use only with CLX6B-FKC
Soldering pad:
Average ramp-up rate = 4ºC/s max.
Average ramp-up rate = 4ºC/s max
Solder
Avera^Pge^rer^ham^eap^t-u^tep^mra^pte^er=^at4^uº^rC^e/s⁼m¹a⁰x^{0ºC ~150ºC}
Preheat temperature = 150ºC ~200ºC
PrehePatretehmepaetrtaimturee ==110500sºCm~a2x0.0ºC
Preheat time = 100s max.
Prehe_Rat_at_mim_pe_-d=_o1_w2_n0s_ram_ta_ex_{= 6ºC/s max.}
Ramp-down rate = 6ºC/s max.
Ramp_P-d_eo_aw_kn_tr_ea_mte_p=_er6_aº_tC_u/_rs_em₌a₂x_{30ºC max.}
Peak t_Te_im_mp_eer_wat_iu_thre_in=₅2_ºC50_oºC_{f a}m_ca_tux _{al Peak Temperature = 10s max.}
Time
D^wiu^thraⁱⁿti⁵o^ºn^Ca^ob^f o^av^cte^ua1^l8^P3^eº^aC^k
Temperature =
is 80s max.
10s
max
Duration above 217ºC is 60s max
Peak temperature = 250ºC max.
Time within 5ºC of actual Peak Temperature = 10s max.
Duration above 217ºC is 80s max.
Only use LP6-NPP1-01-N1 ^[13]
Solder = Low Lead-free
Average ramp-up rate = 3ºC/s max.
Preheat temperature = 130ºC ~170ºC
Preheat time = 120s max.
Ramp-down rate = 6ºC/s max.
Peak temperature = 213ºC max.
Time within 3ºC of actual Peak Temperature = 25s max.
Duration above 200ºC is 40s max.
Recommended solder pad design for heat dissipation (2-pin SMD LED):
7.0
Copyright © 2010 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo and XLamp are registered trademarks
2.6 ^{oCfopCyrerieg,hItn©c. 2014 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the Cree logo are registered trademarks of Cree, Inc.}
10