HR151-2812 Datasheet, PDF (5/7 Pages) Crane Aerospace & Electronics. – DC/DC Converters 12 & 28 Volt Input

DC/DC Converters
Solder Seal
BOTTOM VIEW CASE F4
MTO Series and HR153 Series
Squared corner and dot on top
of case indicate pin one.
1.173
(29.79)
1
2
3
4
5
0.040 dia.
(1.02)
Solder Tip-off
10
9
8
7
6
0.173
(4.39)
0.000
hr150 series
20 Watt
Seal hole: 0.083 ±0.003 (2.11 ±0.08)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Case F4, Rev B, September 21, 2005
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2005 Interpoint Corp. All rights reserved.
Figure 3: Case F4 – HR153
­