FMH-461 Datasheet, PDF (5/9 Pages) Interpoint Corporation Company – EMI INPUT FILTER 28 VOLT INPUT

CASES
CASE G
Squared corner and dot on top
of case indicate pin one.
CASE G
BOTTOM VIEW
Flanged package
See Figures 25 - 27
for pin configuration
2.005 max
(50.93)
1.130 max
(28.70)
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover MHF+ Series and FMH Filter
Kovar/Nickel
SMHF
Cold Rolled Steel/Nickel
Pins #52 alloy (all cases)
compression glass seal
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.2) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage
the device. Solder pins individually with heat
application not exceeding 300°C for 10 seconds
per pin.
Flange Thickness: 0.047 (1.19)
FIGURE 24: CASE G MAXIMUM DIMENSIONS
BOTTOM VIEW CASE G1
Flanged cases: Designator "F" required in Case Option position of model number
MHF+ Series Single and Dual, LIM5050 Module: Screening – Standard, ES, or 883
SMHF Series, SLIM5050 Module: Screening – Space Standard, H, or K
Seam Seal Projection Weld
Squared corner and dot on top
of case indicate pin one.
0.960
(24.38)
0.030 dia.
(0.76)
0.560
(14.22)
1
2345
0.160
(4.06)
0.000
8
7
6
0.128 dia
(3.25)
FIGURE 25: CASE G1
Note: Although every effort has been made to render the case drawings at actual size, variations in the printing process may cause some distortion. Please refer
to the numerical dimensions for accuracy.
B8-15