PIN-001 Datasheet, PDF (2/2 Pages) Interpoint Corporation Company – ACCESSORY PIN TERMINAL ADAPTOR

PIN
ADAPTOR
ACCESSORY
TERMINAL ADAPTOR
R 0.100 (2.54)
0.468 (11.89)
0.425 (10.80)
0.218 (5.54)
0.125 (3.18)
± 0.010 (0.25)
0.180
(4.57)
0.063 (1.60)
DIA.
0.040 (1.02) DIA.
0.045 (1.14) DIA.
Nominal dimensions in inches (mm)
Tolerance: ±0.005 (±0.13) for three decimal places, ±0.01 (±0.3) for two decimal places.
FIGURE 1: PIN-001 DIMENSIONS
To prevent unwanted solder reflow, Interpoint suggests the use of SN 96 (high-temp solder) to connect the
PIN to the converter terminal and SN 62 to connect the PIN to the board. The soldering restrictions referenced
on the data sheets of the listed Interpoint products are 300°C for a maximum of 10 seconds per terminal.
PIN adaptors are designed to be used with case U1 (see Section B8).
B7-4
91113-001-DTS Rev A
DQ# 5022
All technical information is believed to be accurate, but no responsibility is
assumed for errors or omissions. Interpoint reserves the right to make changes in
products or specifications without notice. Copyright © 1996 - 1999 Interpoint. All
rights reserved.