RI-60 Datasheet, PDF (1/2 Pages) Coto Technology – Dry Reed Switch

RI-60 Series Dry Reed Switch
RI-60 Series
Ultra-miniature dry-reed switch hermetically sealed in a gas-filled
glass envelope. Single-pole, single-throw (SPST) type, having
normally open contacts, and containing two magnetically actuated
reeds.
The switch is of the double-ended type and may be actuated by an
electromagnet, a permanent magnet or a combination of both.
The device is intended for use in relays, sensors, pulse counters or
similar devices.
RI-60 Series Features
Ideal for ATE switching
Contact layers: gold, sputtered ruthenium
Superior glass-to-metal seal and blade alignment
Excellent life expectancy and reliability
Dimensions in inches (mm)
General data for all models RI-60
AT-Customization / Preformed Leads
Besides the standard models, customized products
can also be supplied offering the following options:
! Operate and release ranges to customer specification
! Cropped and/or preformed leads
Loaded conditions (resistive load: 5 V; 100 mA;
operating frequency: 125 Hz)
Life expectancy: min. 2 x 10⁷ operations with a failure
rate of less than 10^-8 with a confidence level of 90%.
End of life criteria:
Contact resistance > 1Ω after 2.5 ms
Release time > 1 ms (latching or contact sticking).
Coils
All characteristics are measured using the Philips
standard coil. For definitions of the Philips Standard
Coil, refer to the Reed Switch Technical & Application
Information Section of this catalog.
Loaded conditions (resistive load: 20 V; 500 mA;
operating frequency: 125 Hz)
Life expectancy: min. 2 x 10⁷ operations with a failure
rate of < 10^-8 with a confidence level of 90%.
End of life criteria:
Life expectancy and reliability
The life expectancy data given below are valid for a coil
Contact resistance > 2Ω after 2.5 ms
Release time > 2.5 ms (latching or contact sticking).
energized at 1.25 times the published maximum operate
value for each type in the RI-60 series.
Switching different loads involves different life expect-
ancy and reliability data. Further information is avail-
No-load conditions (operating frequency: 100 Hz) ^{able on request.}
Life expectancy: min. 10⁹ operations with a failure rate
of less than 2 x10^-10 with a confidence level of 90%.
End of life criteria:
Contact resistance > 1Ω after 2 ms
Release time > 2ms (latching or contact sticking).
Mechanical Data
Contact arrangement is normally open; lead finish is
tinned; net mass is approximately 90 mg; and can be
mounted in any position.
102 COTO TECHNOLOGY (USA) Tel: [phone] / Fax [phone] (Europe) Tel: [phone] / Fax [phone]