RI-26 Datasheet, PDF (1/2 Pages) Coto Technology – Dry Reed Switch

RI-26 Series Dry Reed Switch
RI-26 Series
Close differential micro dry-reed switch hermetically sealed in a gas-filled
glass envelope. Single-pole, single-throw (SPST) type, having normally
open contacts, and containing two magnetically actuated reeds.
The switch is of the double-ended type and may be actuated by an electro-
magnet, a permanent magnet or a combination of both.
The device is intended for use in applications with small hysteresis in
switching behavior.
RI-26 Series Features
Close differential reed switch
Contact layers: gold, sputtered ruthenium
Superior glass-to-metal seal and blade alignment
Excellent life expectancy and reliability
General data for all models RI-26
Dimensions in inches (mm)
AT-Customization / Preformed Leads
Besides the standard models, customized products can
also be supplied offering the following options:
! Operate and release ranges to customer specification
! Cropped and/or preformed leads
Coils
All characteristics are measured using the Philips
Standard Coil. For definitions of the Philips Standard
Coil, refer to “Application Notes” in the Reed Switch
Technical & Application Information Section of this
catalog.
Release time > 2ms (latching or contact sticking).
Loaded conditions (resistive load: 20 V; 500 mA;
operating frequency: 125 Hz)
Life expectancy: min. 5x10⁷ operations with a failure
rate of less than 5x10^-9 with a confidence level of 90%.
End of life criteria:
Contact resistance > 2Ω after 2.5 ms
Release time > 2.5 ms (latching or contact sticking).
Switching different loads involves different life expect-
ancy and reliability data. Further information is avail-
able on request.
Life expectancy and reliability
The life expectancy data given below are valid for a coil
energized at 1.5 times the published maximum operate
value for each type in the RI-26 series.
Mechanical Data
Contact arrangement is normally open; lead finish is
tinned; net mass is approximately 190 mg; and can be
mounted in any position.
No-load conditions (operating frequency: 100 Hz)
Life expectancy: min. 3x10⁸ operations with a failure
rate of less than 0.9x10^-9 with a confidence level of
90%.
End of life criteria:
Contact resistance > 1Ω after 2ms
Shock
The switches are tested in accordance with “IEC 68-2-
27”, test Ea (peak acceleration 50 G, half sinewave;
duration 11 ms). Such a shock will not cause an open
switch (no magnetic field present) to close, nor a switch
kept closed by an 80 AT coil to open.
114 COTO TECHNOLOGY (USA) Tel: [phone] / Fax [phone] (Europe) Tel: [phone] / Fax [phone]