K2010_15 Datasheet, PDF (7/11 Pages) COSMO Electronics Corporation – 6PIN PHOTOTRANSISTOR PHOTOCOUPLER

cosmo
K2010 Series
6PIN PHOTOTRANSISTOR
PHOTOCOUPLER
 Recommended Soldering Conditions
(a) Infrared reflow soldering：
 Peak reflow soldering：
260℃ or below (package surface temperature)
 Time of peak reflow temperature：
10 sec
 Time of temperature higher than 230℃：
30-60 sec
 Time to preheat temperature from 180~190℃： 60-120 sec
 Time(s) of reflow：
Two
 Flux：
Rosin flux containing small amount of chlorine (The
flux with a maximum chlorine content of 0.2 Wt% is
recommended.)
Recommended Temperature Profile of Infrared Reflow
260℃
10 sec Max.
230℃
190℃
180℃
60-120 sec
t (s)
30-60 sec
(b) Wave soldering：
 Temperature：
 Time：
 Preheating conditions：
 Time(s) of reflow：
 Flux：
260℃ or below (molten solder temperature)
10 seconds or less
120℃ or below (package surface temperature)
One
Rosin flux containing small amount of chlorine (The flux with a maximum
chlorine content of 0.2 Wt% is recommended.)
(c) Cautions：
 Fluxes：
Avoid removing the residual flux with freon-based and chlorine-based
cleaning solvent.
 Avoid shorting between portion of frame and leads.
Cosmo Electronics Corp.
Document No. 69P01001.2
-7-
http://www.cosmo-ic.com