8A-SERIES Datasheet, PDF (7/10 Pages) –

˙Precautionsʢ8Aɾ8Bɾ8Cɾ8Dɾ8Eɾ8Fɾ8Jɾ8Sɾ8SSʣ
1. Soldering SpeciÄcations
ᾇManual soldering
Device É¿ Solder iron
ᶃ420ˆ Max. 3 sec. Max.
ᾈAuto soldering
ᶄ275ˆ Max. 6 sec. Max.
The above-stated soldering conditions shall apply only
to switches with straight terminals. Auto soldering is
not possible with right-angle terminals. Switches with
right-angle terminals should be soldered manually
according to the conditions speciÄed in (1) above.
ᾉWhen soldering two or more terminals to the common
land, use the solder resist to isolate the terminals.
2.Flux Cleaning
ᾇSolvent : Fluorine or Alcohol type.
ᾈ8A/B/C/D/E/F/J/S series are not washable. To wash
the PC board, clean the soldering surface of the PC
board with a brush so that the switch is not exposed
to the cleaning solution.
ᾉCleaning after soldering should be done after the
terminal temperature falls to 90ˆ or below, or after
leaving the switch for Äve minutes or longer at room
temperature.
3. Mounting
˔Do not bend the terminals before mounting the
switch on the PC board.
˔After mounting the switch, do not place the device
in such a way that the device weight will be applied
on to the actuator of the switch.
˔For switches with straight terminals, solder the
switch on the PC board after Äxing the switch on the
panel with a nut.
˙Packaging SpeciÄcation
Perforated
Plastic
Bags
25 pcs/pack
ʢONʣɿMomentary.