DRS Datasheet, PDF (4/4 Pages) Copal Electronics – Hyper-Miniature Dip Rotary Switches

DRSɾDRR7000C/8000C ^Washable
˙ PCB Footprints
Terminal style
PC
Straight
Footprint dimensions
ɹɹʢ_{Top viewʣ}
Right Angle
˙ 7HJRHNPUN :WLJPÄJH[PVUZ
Series
DRS7000C/8000C
DRR7000C/8000C
:[PJR;\IL :WLJPÄJH[PVUZ
˞ Order in 50 piece increments.
˙ :VSKLYPUN :WLJPÄJH[PVUZ
Ê¢1Ê£Manual Soldering
350ˆ, 3 sec. Max
Ê¢2Ê£Wave Soldering
Immerse the switch two times for the portion from the front
end of terminal to the back side of PCB for 5 to 6 seconds
in the 260ʶ3ˆ soldering pot.
˙ Flux Cleaning
After soldering, wait until the switches cool down to
room temperature (30ˆ or below) before washing. If the
switches are cleaned while still above 30ˆ, a vacuum
will occur which will cause the cleaning solution to be
sucked into the switches.
˙ Switch Operation
Use a screwdriver for setting position of the actuator.