English
Language : 

DP7409 Datasheet, PDF (1/16 Pages) Copal Electronics – Quad Digital Potentiometers
Quad Digital Potentiometers
(DP) with 64 Taps and 2-wire Interface
DP7409
FEATURES
Four linear taper digital potentiometers
64 resistor taps per potentiometer
End to end resistance 2.5kŸ, 10kŸ, 50kŸ or
100kŸ
2-wire interface (I2C like)
Low wiper resistance, typically 80Ÿ
Four non-volatile wiper settings for each
potentiometer
Recall of saved wiper settings at power-up
2.5 to 6.0 volt operation
Standby current less than 1µA
1,000,000 nonvolatile WRITE cycles
100 year nonvolatile memory data retention
24-lead SOIC and 24-lead TSSOP
Write protection for data register
For Ordering Information details, see page 15.
PIN CONFIGURATION
TSSOP (Y)
SOIC (W)
SDA 1
A1 2
RL1 3
RH1 4
RW1 5
GND 6
NC 7
RW2 8
RH2 9
RL2 10
SCL 11
A3 12
24 WP
23 A2
22 RW0
21 RH0
20 RL0
19 VCC
18 NC
17 RL3
16 RH3
15 RW3
14 A0
13 NC
VCC 1
RL0 2
RH0 3
RW0 4
A2 5
WP 6
SDA 7
A1 8
RL1 9
RH1 10
RW1 11
GND 12
24 NC
23 RL3
22 RH3
21 RW3
20 A0
19 NC
18 A3
17 SCL
16 RL2
15 RH2
14 RW2
13 NC
DESCRIPTION
The DP7409 is four Digital Potentiometers
(DP) integrated with control logic and 16 bytes
of NVRAM memory.
A separate 6-bit control register (WCR) independently
controls the wiper tap position for each DP.
Associated with each wiper control register are four
6-bit non-volatile memory data registers (DR) used for
storing up to four wiper settings. Writing to the wiper
control register or any of the non-volatile data
registers is via a 2-wire serial bus (I2C-like). On
power-up, the contents of the first data register (DR0)
for each of the four potentiometers is automatically
loaded into its respective wiper control register
(WCR).
The Write Protection (¯W¯P¯) pin protects against
inadvertent programming of the data register.
The DP7409 can be used as a potentiometer or as a
two terminal, variable resistor. It is intended for circuit
level or system level adjustments in a wide variety of
applications.
FUNCTIONAL DIAGRAM
SCL
SDA
WP
A0
A1
A2
A3
RH0
RH1
RH2
RH3
2-WIRE BUS
WIPER CONTROL
INTERFACE
REGISTERS
RW0
RW1
NONVOLATILE
RW2
CONTROL LOGIC
DATA
REGISTERS
RW3
RL0
RL1
RL2
RL3
© NIDEC COPAL ELECTRONICS CORP.
1
Characteristics subject to change without notice
Doc. No. MD-2010 Rev. K