SH-7010TA Datasheet, PDF (3/6 Pages) Cooper Bussmann, Inc. – ROTARY CODED SWITCHES SMD

COPAL ELECTRONICS
SH-7000
ROTARY CODED SWITCHES (SMD)
˙MECHANICAL CHARACTERISTICS ˙ENVIRONMENTAL CHARACTERISTICS
No. of positions
Adjustment torque
Stepping angle
Solderability
Soldering heat
Shear (adhesion)
Substrate bending
Pull-off strength
10, 16
3 ~ 20 mN·m { 3~ 204 gf·cm} maximum
36° (10 positions)
22.5° (16 positions)
245 ± 3 °C, 2 ~ 3 s
Flow : 260 ± 3 °C as the temperature in
a pot of molten solder, immer-
sion from head of terminal to
backside of board,5 ~ 6 s, two
times maximum
Reflow : Peak temperature 255 °C
(Please refer to the profile below.)
Vibration
Amplitude 1.5 mm or Acceleration 98 m/s²,
10-500-10 Hz, 3 directions for 2 h each
Shock
490 m/s², 11 ms
6 directions for 3 times each
Load life
10000 steps minimum, DC5 V, 100 mA
Humidity
High temperature exposure
40 °C, Relative humidity 90 ~ 95 %,
240 h
85 °C, 96 h
105 °C, 96 h (Gray code)
Low temperature exposure
−40 °C, 96 h
Thermal shock
−40 (0.5 h) ~ 85 °C ( 0.5 h ), 5 cycles
−40 (0.5 h) ~ 105 °C ( 0.5 h ), 5 cycles (Gray code)
Manual solderingɿ
350 ± 10 °C, 3 ~ 4 s
5 N {0.51 kgf} 10 s
Width 90 mm, bend 3 mm, 5 s, 1 time
5 N {0.51 kgf} 10s
{ } : Reference only
ʪReflow profile for soldering heat evaluationʫ
(°C)
250
Peak
:
250
+5
0
°C
Over 230 °C
200
180 °C
Pre Heating Zone
150 150 °C
90 ± 30 s
100
30 ± 10 s
50
Heating time ^{Soldering Zone}
Ϧϑϩʔճ਺ɿ̎ճɹReflow : two times maximum
˙OUTLINE DIMENSIONS
● SH-7010A (Real code)
● SH-7030A (Complementary code)
Production date code
7.3
6 – 0.6
t = 0.15
Unless otherwise specified, tolerance: ± 0.3 (Unit: mm)
● SH-7010B (Real code)
● SH-7030B (Complementary code)
Production date code
7.3
ᰔ
ᰑ
6 – 0.6
t = 0.15
ᰒ
3.75
2.54
2.54
0.7 W × 2.8 L × 1 D
Marking appears only with complementary code
ᰒ
ᰘ
0.7 W × 2.8 L × 1D
3.75
2.54
2.54
Marking appears only with complementary code
˙ Specifications are subject to change without notice. Specifications in this catalog are for reference. The formal specification sheets will be submitted upon request.