OVA5GA3AB Datasheet, PDF (2/2 Pages) Connor-Winfield Corporation – 14 PIN DIP 5.0V HCMOS OCVCXO

THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX [phone].
PHONE [phone].
www.conwin.com
PRODUCT DATA
CRYSTAL CONTROLLED OSCILLATORS
Notes:
1) Initial calibration @ 25°C, Vc = 2.50V at time of shipm ent.
2) Frequency vs. temperature stability, -20 to 70°C, referenced to 25°C.
3) Frequency stability per 5% change in supply voltage.
4) Frequency stability per 5% change in load
5) Inclusive of calibration, operating tem perature range, supply voltage chang e, load
change, shock and vibration and ag ing over 20 years.
6) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.5ppm of nominal.
7) Referenced to Fo @ 25°C, Positive Transfer Characteristic.
8) Supply voltage at 5.00 Vdc.
SHEET
ENVIRONMENTAL CHARACTERISTICS
Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute
transition.
Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20
seconds.
SOLDERING
Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage.
Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C
±5°C for 20 Seconds.
MECHANICAL CHARACTERISTICS
Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15mi nute cycles 12 times each
perpendicular axis.
Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction.
Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C.
0.330 MAX
(8.38mm)
CONTROL VOLTAGE
4.5
20K
POT
DATASHEET #: ^Cx082 PAGE 2 OF 2
REV: ⁰¹
DATE: ^04/06/05
Specifications subject to change without notice.
aCopyright 2001 Connor-Winfield all rights reserved.