ABOV5S3E Datasheet, PDF (2/2 Pages) Connor-Winfield Corporation – CRYSTAL CONTROLLED OSCILLATORS

THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX [phone].
PHONE [phone].
WWW.CONWIN.COM
PRODUCT
DATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
PACKAGE CHARACTERISTICS
Package
Solder Process
TABLE 6.0
Metal package: solder sealed, grounded case, solder tinned pins.
RoHS 5/6 compliant, see solder profile below.
ENVIRONMNETAL CHARACTERISTICS
TABLE 7.0
Shock
100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C
Vibration
0.06” D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D, Test
condition A
Notes:
1) Labels will include the calibration frequency at the time of ship.
2) Initial calibration referenced to Fo at time of shipment @ 25C, Vc=2.5Vdc.
3) Frequency vs. temperature stability, absolute change over 0 to 70C.
4) After ten days of continuous operation.
5) Allen Variance: 1 second, 100 average.
6) Vcc = 5.0Vdc.
7) From Vcc=90% of final value. No more than 16 transitions at start-up before oscillator
has started.
8) Measured @ 0C, within 5 minutes, referenced one hour after turn-on.
9) After re-stabilization time.
10) Positive slope.
11) HCMOS load.
12) For a given off time, the time required to meet daily aging, short-term stability and TDEV
requirements.
Pin Connections
CONTROL VOLTAGE
Labeling Diagram
MODEL
ABOV5S3E
FREQUENCY 10.000MHz
DATE CODE
0746
CAL. FREQ. 10.000000
.500
12.700mm
Package Outline
Test Circuit
Solder Profile
REF.
SUPPLY
+4.5Vdc
DATA SHEET #: ^Cx057 PAGE 2 OF 2
REV: ⁰¹
DATE: ^11/02/07
Ramp-Up Rate
Temperature 3°C/second max.
225°C
from 150°C to 225°C.
183°C
150°C
225°C
tp
Ramp-Down Rate
6°C/second max.
100°C
25°C
0
60-120s
10-30s
Max.
60-150s Max.
360 Sec. Max.
Time
Specifications subject to change without notice.
aCopyright 2007 Connor-Winfield all rights reserved.