6115 Datasheet, PDF (2/2 Pages) Connor-Winfield Corporation – 5.0V HCMOS Surface Mount Crystal Clock Oscillator

2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: [phone]
Fax: [phone]
www.conwin.com
Package
Package Characteristics
Hermetically sealed ceramic package and metal cover
Suggested Pad Layout
Environmental Characteristics
Temperature Cycle
The specimen shall meet electrical characteristics after
tested 5 cycles of -55°C / 30 minutes and +125°C / 30 minutes
Hermetical No bubbles appear in Flourinert (FC-43) at 125°C ±5°C for 5 minutes
Solvent Resistance
Marking will withstand immersion in
Isopropyl Alcohol or Trichloroethylene
Soldering
General Conditions
260°C max x 10 sec max x 2 times max or
230°C max x 180 sec max x 1 time
Typical Operation Data
(Vapor phase reflow)
20 to 100 sec up to 215°C, 50 sec
at 215°C, then down to room temperature per 1 to 5°C / sec
Free Drop
Mechanical Characteristics
The specimen shall meet electrical characteristics after tested 3 times,
Free Drop testing on the hard wooden board from a height of 75 cm.
Vibration
The specimen shall meet electrical characteristics after tested
by the following conditions: 10-55Hz 1.5mm Amplitude,
55-2000 Hz 20 G's, 2 hours for each plane
Thermal Shock
After applied Thermal Shock of 260°C
max x 10 sec max x 2 times, or 230°C max x 180 sec max,
the specimen shall meet electrical characteristics
Solderability
(EIAJ-RCX-0102.101 Condition 1a)
1) Flux: MIL-F-14256 (WW Rosin=25%, Isopropyl Alcohol = 75%)
2) Solder: QQ-S-571 (Sn = 63%, Pb = 37%)
3) Solder bath temperature: 235°C ±5°C
4) Depth of immersion: Up to electrical terminal
5) Immersing time: Within 2 sec ±0.5 sec into solder bath
After performing the above procedures, a newly soldered coverage shall be greater than 90%
Pad Connection
1: Tri-State E/D
2: Ground
3: Output
4: VDD
Bypass capacitor, C-by, should
be ceramic capacitor ≥ .01uf.
POWER
SUPPLY
Test Circuit
OSCILLOSCOPE
PROBE
OSC
INPUT FOR E/D
FREQ
COUNTER
Output Waveform
TF
TR
90%
50%
10%
GND. LEVEL
T1
T0 = 1/ fo
SYMMETRY=(T1/T0)X100%
Dimensional Tolerance: ±.008 (.20mm)
Tape and Reel Dimensions
Ordering Information
6115 - 20.00 MHz
CLOCK
SERIES
CENTER
FREQUENCY
Meets EIA-481A and EIAJ-1009B
3,000 PCS/Reel
Dimensional Tolerance: ±.02" (.508mm)
± . 0 0 5 " (.127mm)
Specifications subject to change without notice. All dimensions in inches. © Copyright 1998 The Connor-Winfield Corporation
Bulletin
Page
Revision
Date
Sm083
2 of 2
01
30 May 2002