FTS125-CTV-010.0 Datasheet, PDF (1/10 Pages) Connor-Winfield Corporation – GPS Disciplined Oscillators

Available at Digi-Key
www.digikey.com
125 Series
FTS125-CTV-010.0 MHz
GPS Disciplined Oscillators
2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: [phone]
Fax: [phone]
www.conwin.com
D
A
T
A
S
H
E
E
T
General Description
The FTS125-CTV-010.0 MHz Frequency and Time
Standard module is a TCXO GPS driven, mixed-signal
phase lock loop, providing a 1 PPS CMOS output from
a Connor-Winfield GPS timing receiver and generating
a 10 MHz CMOS and a 10 MHz SINE output from an
intrinsically low jitter voltage controlled crystal oscillator.
The FTS125 can lock to a 10 MHz reference derived
from the on-board GPS receiver or an external 10 MHz
reference or to an external 1 PPS reference. Alarms
are provided to indicate Loss-of-Lock, Holdover, and
Antenna Fault. The on-board GPS receiver requires an
outdoor mounted GPS antenna for the best stability and
consistent performance.
The mode control inputs are used to manually
switch between references and/or holdover. The user
application should monitor the alarm outputs and manually switch modes as needed.
Serial I/O lines provide access to the NMEA messages from the GPS receiver
(referenced in the Connor-Winfield’s Wi125 User Manual. Contact Connor-Winfield Sales
for a copy). The serial I/O lines can be used to access GPS timestamp information, or to
verify that the receiver has recovered from an alarm condition. The reset is used to reset
the GPS receiver (if needed).
Features
• Phase locked 10 MHz output
• 1 PPS output
• 3 selectable references: GPS, External 10 MHz or External 1 PPS
• Holdover
• Three alarm outputs. (Loss-of-Lock, Holdover and Antenna Fault)
• Serial input and output ports (GPS receiver)
• Master reset
• +3.3 Volt power supply
• Commercial Temp (0-70° C)
• Meets ITU-T G.811 Wander Generation Mask
• Meets ETSI-PRC Wander Generation Mask (with OCXO reference)
• MCX GPS Antenna Connection
• Fixed Position Unit
• Package: 32-pin Through-Hole
• Physical Dimensions: 4.15” x 3.3” x 0.718” (105.41mm x 83.82mm x 18.22mm)
Bulletin
Revision
Date
Issued By
SG185
02
03 Jan 12
ENG