XFL6060-473 Datasheet, PDF (1/2 Pages) Coilcraft lnc. – Shielded Power Inductor

Document 796A-1
Shielded Power Inductor XFL6060-473

  _{Part number}1
XFL6060-473ME_
  _Inductance2 _  DCR (mOhms)³
±20% (µH)
typ    max
47
68.4
75.3
• Designed for STMicroelectronics LED5000 3 A monolithic
step-down current source
• High current and low DCR; soft saturation
Core material Composite
Terminations  RoHS compliant tin-silver over copper.
Environmental  RoHS compliant, halogen free
Weight  1.3 g
Ambient temperature  –40°C to +125°C with (40°C rise) Irms current.
Maximum part temperature  +165°C (ambient + temp rise). Derating.
Storage temperature  Component: –40°C to +165°C.
Tape and reel packaging: –40°C to +80°C
Resistance to soldering heat  Max three 40 second reflows at
+260°C, parts cooled to room temperature between cycles
Moisture Sensitivity Level (MSL)  1 (unlimited floor life at <30°C /
85% relative humidity)
Failures in Time (FIT) / Mean Time Between Failures (MTBF)
38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332
Packaging  250/7″ reel; 750/13″ reel  Plastic tape:  16 mm wide,
0.3 mm thick, 12 mm pocket spacing, 6.23 mm pocket depth
PCB washing  Tested to MIL-STD-202 Method 215 plus an additional
aqueous wash. See Doc787_PCB_Washing.pdf.
 SRF typ⁴
(MHz)
7.8
  ^{Isat (A)5}
  Irms (A)⁶
10% drop 20% drop 30% drop 20°C rise  40°C rise
1.4
1.6
1.8
2.8
3.7
1. When ordering, please specify packaging code:
XFL6060-473MEC
Packaging: C = 7″ machine-ready reel. EIA-481 embossed plastic tape (250 parts per full reel).
B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added
($25 charge), use code letter C instead.
D = 13″ machine-ready reel. EIA-481 embossed plastic tape. Factory order only, not stocked
(750 parts per full reel).
2. Inductance tested at 100 kHz, 0.1 Vrms, 0 Adc.
3. DCR measured on a micro-ohmmeter.
4. SRF measured using Agilent/HP 4395A or equivalent.
5. DC current at 25°C that causes the specified inductance drop from its value without current.
Click for temperature derating information.
6. Current that causes the specified temperature rise from 25°C ambient. This information is for reference only
and does not represent absolute maximum ratings. Click for temperature derating information.
7. Electrical specifications at 25°C.
Refer to Doc 362 “Soldering Surface Mount Components” before soldering.
Irms Testing
Irms testing was performed on
0.75 inch wide × 0.25 inch thick
copper traces in still air.
Temperature rise is highly
dependent on many factors
including pcb land pattern,
trace size, and proximity to
other components. Therefore
temperature rise should be
verified in application conditions.
Document 796A-1  Revised 09/17/15