PDLF4000L Datasheet, PDF (1/2 Pages) Coilcraft lnc. – SMT Data Line EMI Filters

Document 491-1
SMT Data Line EMI Filters – PDLF
Part
number¹
PDLF4000L_
PDLF4500L_
PDLF3000L_
PDLF3500L_
PDLF2000L_
PDLF2500L_
Lines
4
4
3
3
2
2
Current
max²
(mA)
100
500
100
500
100
500
Inductance
min³
(µH)
5
5
5
5
5
5
DCR max
(mOhms)
250
200
250
200
250
200
1. When ordering, please specify packaging code:
PDLF4500LC
C = 7″ machine ready reel. EIA-481 embossed plastic tape (500 parts
per full reel).
D = 13″ machine ready reel. EIA-481 embossed plastic tape
(2000 parts per full reel).
B = Less than full reel. In tape, but not machine ready. To have a
leader and trailer added ($25 charge), use code letter D instead.
2. Current rating is for each line.
3. Inductance is per winding, tested at 1 MHz.
4. Operating temperature range -40°C to +85°C.
5. Electrical specifications at 25°C.
Refer to Doc 362 “Soldering Surface Mount Components” before soldering.
• Available in 4, 3 and 2-line versions
• See our CCDLF series for 10 and 8-line EMI filters
• Exceptional common mode noise attenuation from 15 MHz
to 300 MHz; passes signal line data below 300 MHz with
minimal attenuation
• DC current capacity of 500 or 100 mA.
• Excellent electrical isolation (300 Vrms)
Designer’s Kit D303 contains four each of all values plus DLF and
CCDLF filters
Core material Ferrite
Terminations RoHS compliant Tin-silver-copper over tin over
nickel over phos bronze terminations. Other terminations available at
additional cost.
Weight 183 – 201 mg
Ambient temperature –40°C to +85°C
Storage temperature Component: –40°C to +85°C.
Packaging: –40°C to +80°C
Resistance to soldering heat Max three 40 second reflows at
+260°C, parts cooled to room temperature between cycles
Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C /
85% relative humidity)
Mean Time Between Failures (MTBF) 26,315,789 hours
Packaging 500/7″reel; 2000/13″ reel Plastic tape: 16 mm wide,
0.35 mm thick, 8 mm pocket spacing, 4.4 mm pocket depth
PCB washing Only pure water or alcohol recommended
Typical Response^*
-10
Differential Mode
0
10
20
Common Mode
30
0.1
1
10
100
Frequency (MHz)
* Measured on HP 8753D network analyzer. Ref: 50 Ohms.
1000
© Coilcraft, Inc. 2009
Specifications subject to change without notice.
Please check our website for latest information.
Document 491-1 Revised 10/30/08