HA3648_15 Datasheet, PDF (1/1 Pages) Coilcraft lnc. – Planar Transformer

Document 710
Planar Transformer For National Semiconductor
LM5037 PWM Controller
• Developed for NSC LM5037 Dual-Mode PWM Controller
• Designed as half bridge in forward topology
• Auxiliary winding provides 10 V to the chipset
• Input voltage range: 36 – 78 V
Core material Ferrite
Terminations  RoHS matte tin over nickel over brass. Other termina-
tions available at additional cost.
Weight  11.8 g
Ambient temperature  –40°C to +85°C
Storage temperature  Component: –40°C to +85°C.
Tape and reel packaging: –40°C to +80°C
Resistance to soldering heat  Max three 40 second reflows at
+260°C, parts cooled to room temperature between cycles
Moisture Sensitivity Level (MSL)  1 (unlimited floor life at <30°C /
85% relative humidity)
Failures in Time (FIT) / Mean Time Between Failures (MTBF)
38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332
Packaging  200 per 13″reel  Plastic tape:  44 mm wide,
0.37 mm thick, 32 mm pocket spacing, 9.35 mm pocket depth
PCB washing  Only pure water or alcohol recommended

Part
Output
  _number1 _{power (W)}
Output
voltage
nom (V)
Output
Primary
Leakage
  _{current  inductance}2   _inductance3   _{DCR max}4
(Adc)
min (µH)
max (µH)
(mOhms)
HA3648-BL_ 50
5
10
30.0
0.040
pri: 6.0
sec: 4.0
aux: 160
  _Pri/sec
Turns ratio
Isolation
pri : sec1 : sec2 : aux (Vdc)
2:1:1:2
1500
1. When ordering, please specify a packaging code:
Packaging:
HA3648-BLD
D = 13″ machine ready reel. EIA-481 embossed plastic
tape (200 per full reel).
B = Less than full reel. In tape, but not machine ready.
To have a leader and trailer added ($25 charge), use
code letter D instead.
2. Inductance measured on an Agilent/HP 4284 between pins 3 and 4 at 250
kHz, 0.1 Vrms, 0 Adc.
3. Leakage inductance measured between pins 3 and 4 at 250 kHz, 0.1 Vrms,
0 Adc with pins 6, 8 and 10 shorted.
4. DCR for the secondary is from pin 6 to pin 10.
5. Electrical specifications at 25°C.
1
0.810
20,57
max
3
4
5
Dot indicates pin 1
10
8
6
0.920
23,37
max
Parts manufactured prior to December 2011
may be marked differently.
Æ
0.080
2,03
0.190
4,82
0.095
2,41
0.800
20,32
10
1
8
3
4
5
6
Recommended
Land Pattern
0.250
6,36
Æ
0.110
2,79
3
Primary
4
1
Aux
5
10
Sec1
8
Sec2
6
0.360
9,14
max
0.006 /0,15
Dimensions are in
inches
mm
Document 710  Revised 02/18/15