ETH1-460_15 Datasheet, PDF (1/2 Pages) Coilcraft lnc. – “PoE Plus” Magnetics – ETH1-460

Document 1008-1
“PoE Plus” Magnetics – ETH1-460
Core material Ferrite
Terminations  RoHS compliant tin-silver-copper over tin over nickel
over phos bronze
Weight  3.6 g
Ambient temperature  –40°C to +85°C
Storage temperature  Component: –40°C to +85°C.
Tape and reel packaging: –40°C to +80°C
Resistance to soldering heat  Max three 40 second reflows at
+260°C, parts cooled to room temperature between cycles
Moisture Sensitivity Level (MSL)  1 (unlimited floor life at <30°C /
85% relative humidity)
Failures in Time (FIT) / Mean Time Between Failures (MTBF)
60 per billion hours / 16,666,667 hours, calculated per Telcordia SR-332
Packaging  250/13″ reel;  Plastic tape:  32 mm wide, 0.5 mm thick,
24 mm pocket spacing, 10.6 mm pocket depth
PCB washing  Tested to MIL-STD-202 Method 215 plus an additional
aqueous wash. See Doc787_PCB_Washing.pdf.
The ETH1-460L_¹ is developed for high power PoE ap-
plications in support of the goals of the IEEE 802.3at-2009
standard. This module is designed for 4-pair cabling plants
at 60 Watts. It exceeds the return loss requirements of
Gbit Ethernet.
This single component solution may be used in place of
two ETH1-230 parts, saving valuable board space.
It has a minimum open-circuit inductance of 350 µH at an
offset current of 35 mA at 25°C ambient temperature, and
can handle 22.5 mA minimum dc offset at 85°C. Typical
temperature rise from 25°C ambient is 7°C with 800 mA
and 10°C with 1000 mA dc current applied to one center
tap of each isolation transformer.Winding to winding isola-
tion is 1500 Vrms. Ambient temperature range: –40°C to
+85°C with 1 A current.
1. When ordering, please specify packaging code:
ETH1-460LD
Packaging: D = 13″ machine-ready reel. EIA-481 embossed plastic tape.
Factory order only, not stocked (250 parts per full reel).
B = Less than full reel. In tape, but not machine ready.
To have a leader and trailer added ($25 charge), use
code letter D instead.
Dimensions
are
in
inches
mm
Document 1008-1  Revised 10/09/12