|
C1539_11 Datasheet, PDF (1/1 Pages) Coilcraft lnc. – Planar Transformer | |||
|
Document 465
Planar Transformer For National Semiconductor
LM5032 PWM Controller
⢠Developed for the NSC LM5032 dual interleaved current mode
PWM controller for applications up to 100 Watts.
⢠Can be used in a dual forward converter or in both interleaved
power stages of a high-current converter.
⢠Low leakage inductance, excellent DCR
⢠Interwinding isolation: 1500 Vdc.
Core materialâFerrite
Terminationsâ RoHS Matte tin over nickel over brass
Weightâ 10.2 g
Ambient temperatureâ â40°C to +85°C
Storage temperatureâ Component: â40°C to +85°C.
Tape and reel packaging: â40°C to +80°C
Resistance to soldering heatâ Max three 40 second reflows at
+260°C, parts cooled to room temperature between cycles
Moisture Sensitivity Level (MSL)â 1 (unlimited floor life at <30°C /
85% relative humidity)
Failures in Time (FIT) / Mean Time Between Failures (MTBF)
38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332
Packagingâ 200 per 13â³ reelâ Plastic tape:â 44 mm wide,
0.37 mm thick, 32 mm pocket spacing, 9.35 mm pocket depth
PCB washingâ Only pure water or alcohol recommended
Part
Output
â number1 power (W)
Output
voltage
nom (V)
Output
Primary
Leakage
â current âinductance2 â inductance3 DCR max
(A rms)
min (µH)
max (µH)
(mOhms)
C1539-AL_
100
12
8.33
320.0
0.25
pri: 63.0
sec: 15.0
â Pri/sec
Turns ratio Isolation
pri : sec
(Vdc)
2:1
1500
1. When ordering, please specify a packaging code:
Packaging:
C1539-ALD
D = 13â³ machine ready reel. EIA-481 embossed plastic
tape (200 per full reel).
B = Less than full reel. In tape, but not machine ready.
To have a leader and trailer added ($25 charge), use
code letter D instead.
2. Inductance measured on an Agilent/HP 4284 between pins 2 and 4 at 250
kHz, 0.1 Vrms, 0 Adc.
3. Leakage inductance measured between pins 2 and 4 at 100 kHz, 0.1 Vrms,
0 Adc with pins7 and 9 shorted.
4. Storage and ambient operating temperature range: â40°C to +85°C.
5. Electrical specifications at 25°C.
1
2
0.810
20,57
max
3
4
5
0.360
9,14
max
Dot indicates pin 1
0.920
23,37
max
0.820
20,83
10
2
9
9
8
0.190
4,83
7
6
4
7
Ã
0.080
2,03
Recommended
Land Pattern
Parts manufactured prior
to December 2011 may
be marked differently.
0.006 /0,15
Dimensions are
in
inches
mm
2
Primary
4
7
Secondary
9
Document 465â Revised 12/21/11
|