150-01J08L Datasheet, PDF (1/2 Pages) Coilcraft lnc. – 7mm Tunable RF Coils

Document 109-1
7 mm Tunable RF Coils – 146, 150 Series
Unshielded Styles
0.268 ±0.005
6,81 mm ±0,13
square
0.450 ±0.020
11,43 ±0,51
Coilcraft tunable coils provide the compactness of a
7 mm coil and the low drift reliability of an insert molded
coil.
Standard inductance values range from less than 0.05
µH to over 0.5 µH. 150 Series coils with a tap are also
available to meet specific requirements.
The windings of these economical coils are precision
molded into a single piece of polypropylene for mechani-
cal and electrical stability. Optional plated brass shield
cans with solderable tabs provide integral shielding and
additional mounting stability.
These parts can be odered without cores for use as fixed
inductors.
Coilcraft Designer’s Kit M302 contains samples of all
standard 7 mm and 10 mm tunable inductors. To order,
contact Coilcraft or visit http://order.coilcraft.com.
0.138 ±0.040
3,5 ±1,02
0.177 ±0.005
4,5 ±0,13
Unshielded
Weight: 146 series 0.44 – 0.70 g
150 series 0.45 – 0.61 g
With shield can
0.91 – 1.12 g
0.88 – 1.08 g
Start
0.177 ±0.005
4,5 ±0,13
With Shield Can
0.73,060max
0.475
12,1
max
0.020
0,51
±0.002
±0.05
dia
Finish
0.039 ±0.010
1,0 ±0,25
0.280
7,1
Tab
centers
Start
0.216
5,5
dia
hole
0.138 ±0.010
3,51 ±0,25
Tab length
Finish
Recommended
Board Layout
0.060 (for shield
1,52 ^{can tabs)}
0.0885
2,25
0.0885
CL
2,25
0.040
1,016
(2)
0.140
3,55
CL
Resistance to soldering heat: Wave solder only. Recommended maximum
board surface temperature of 168°C (334°F) for no more than three seconds.
Pre-heating is recommended to minimize time over the solder nozzle.
Terminations Series 146 leads: Tin-silver over copper
Series 150 leads: Matte tin over copper
Shield can tabs: Tin-silver over nickel over brass
Specifications subject to change without notice.
Please check our website for latest information.
Document 109-1 Revised 9/30/08
© Coilcraft, Inc. 2008