EV9900A Datasheet, PDF (9/27 Pages) CML Microcircuits – Test Access for Important Signals

Evaluation Kit for CMX990
EV9900A
4. Signal Lists
CONNECTOR PINOUT
Connector Connector
Ref.
Pin No.
Signal
Name
J1
N/A
REFIN
J2
N/A
RXIN1
J3
N/A
RXIN2
J4
N/A
IFOUT
J5
N/A
IF IN
J6
N/A
TXI
J7
N/A
TXQ
J8
N/A
TX VCO O/P
J9
N/A
TXOUT
J10
N/A
MAIN LO
J11
N/A
AUX LO
J12
3
+7.2V
J12
2
+3.5V
J12
1
GND
J13
1 – 40
HOST
INTERFACE
J14
1–8
TX/RX/I/Q
J15
1,3,5,7
TX/RX/I/Q
J15
2
DAC3
J15
4
DAC2
J15
6
ADC5
J15
8
ADC4
J16
VOID
VOID
J17
N/A
N/A
J18
N/A
RF_ANT
Signal
Type
RF / Clock
RF
RF
RF
RF
BASEBAND
BASEBAND
RF
RF
RF
RF
DC
DC
DC
LOGIC
BASEBAND
BASEBAND
BASEBAND
BASEBAND
BASEBAND
BASEBAND
N/A
N/A
RF
Description
Clock input / output. By selecting coupling
capacitors (C3 / C4) this port may be used to
monitor the on-board 14.4MHz reference or the
external reference input.
Input to receiver LNA.
By selecting components this port may be used
as an LNA output or input to the receiver mixer.
NB: This port is a test port (solder pads)
designed to allow connection of a coax cable.
1^st Mixer Output or input to IF filter (F2).
Output of IF filter (F2) or input to CMX990
receiver IF stages.
EV9900A is not configured to use this port.
EV9900A is not configured to use this port.
Monitor point for Tx VCO feedback signal.
400MHz / 800MHz transmitter output.
Input or output / monitor for main local oscillator.
Input or output / monitor for auxiliary (180MHz)
local oscillator (normally not connected).
7.2V power supply input.
3.5V power supply for RF power amplifier.
Power supply ground.
8 bit parallel interface from CMX990 to host /
controller or PC. See schematics and CMX990
datasheet for details.
EV9900A is not configured to use this port.
EV9900A is not configured to use these pins.
DAC3 output.
DAC2 output.
ADC5 input.
ADC4 input.
Void
EV9900A is not configured to use this
connector.
TX / RX Switch Output (Default configuration of
EV9900A does not use this connector).
Table 1 – Signal List
© 2007 CML Microsystems Plc
9
UM9900A/3