CMX608 Datasheet, PDF (46/70 Pages) CML Microcircuits – Integrated Input and Output Channel Filters

RALCWI Vocoder
CMX608/CMX618/CMX638
5.10.4. 16-bit Write-Only Registers
VCTRL register address $11 (also MVCTRL register address $3C)
15
14
13
12
11
10
0
0
ESTDP ESTDD EDTMFD
0
9
DSTDP
8
DSTDG
7
6
5
4
DSTDD DDTMFG DDTMFD DVDW
3
2
1
PLC FECLOOP ENC
0
DEC
This write-only register controls the Vocoder when it is operating. A change in the state of these
bits may take up to 20ms before any effect is observed. The VCTRL register is mirrored by the
MVCTRL register ($3C). This read-only register holds the last value written to the VCTRL ($11)
register. The MVCTRL register is updated before the value is validated and therefore may be
used as confirmation that a write command to a 16-bit C-BUS register is working.
After the VCTRL command has completed, bit 15 of the STATUS register ($40) will be set to '1'
and, if enabled, IRQN will go low. No other C-BUS registers should be read or written whilst this
command is in progress.
Bit 0
DEC
Decoder Enable: If this bit is set to '1' the device will accept frames of vocoded
audio, decode them, and send the samples to the D/A converter. If this bit is
cleared to '0', any supplied frames will be ignored.
Bit 1
ENC
Encoder Enable: If this bit is set to '1' the device will collect samples from the A/D
converter, encode them and send the vocoded frames to the streaming
ENCFRAME register ($30). If this bit is cleared to '0', no vocoded frames of audio
will be produced.
Note: Setting both DEC and ENC to '1' is the same as setting them both to' '0, as full duplex
operation is not possible with the CMX608/CMX618. In the CMX638, DEC and ENC bits can be
set as above, for half-duplex operation, or both DEC and ENC should be set to '1' for full-duplex
operation. When operating in full-duplex, neither DTMF nor STD functions are supported.
Bit 2
FECLOOP
Repeater Function Enable: If this bit is set to '1' the device will re-apply FEC to the
previously supplied FEC encoded frame, after error correction, and then send it to
the streaming ENCFRAME register ($30). This allows the device to be used in a
repeater. If this bit is cleared to '0', this function is turned off.
This bit is ignored if the ENC bit is set to '1'. If the DEC bit is set to '1', the
supplied frames will also be decoded and sent to the D/A converter.
Bit 3
PLC
Packet Loss Concealment (PLC): If this bit is set to '1' the device’s decoder will
attempt to conceal badly corrupted frames by using a special PLC procedure. If
this bit is cleared to '0', PLC will not be done.
Bit 4
DVDW
Vocoder Data Wanted: If this bit is set to '1', the device will indicate that it is able
to accept another Vocoder frame for decoding, by setting the VDW bit (bit 8) in
the STATUS register ($40). If this bit is cleared to '0', this function is disabled.
 2014 CML Microsystems Plc
46
D/608_18_38/11