English
Language : 

FX105A Datasheet, PDF (10/16 Pages) CML Microcircuits – Tone Detector
Tone Detector
FX105A
1.6.2.9 Calculate Signal to Noise Performance
Worst-case S/N calculations depend on calculation of a value “M” using the formula shown below:
M = RWC3A/ [3 RVC2A]
substituting our example values,
M = 465 x 0.22 / (3 x 200 x 0.01) = 17.05
By substituting this value for M in Figure 5 the minimum required S/N of an in band tone with respect
to an adjacent interfering tone can be found. This has to be increased if the required tone amplitude is
close to the word filter sensitivity VTH.
Figure 5 S/N vs. BW Separation
The following formula expresses the reduction in noise immunity as the input signal approaches the
word filter sensitivity VTH.
required S/N = 20 log (VIN/ [VIN - VTH] ) + S/NFigure 5
If this S/N is better than required for the application, RWC3A can be reduced, or the operating
bandwidth can be increased to obtain a faster tone detection time.
If the S/N performance is not adequate, the operating bandwidth can be reduced toward the MUBW,
or RWC3A can be increased to improve S/N performance at the expense of a slower response time.
© 1999 Consumer Microcircuits Limited
10
D/105A/5