CMDA48 Datasheet, PDF (12/12 Pages) Chicago Miniature Lamp,inc – Power LED (2.5 Watt)

Soldering profile, T_A=25ºC
1. Reflow Soldering Conditions / Profile
[]
260
240
220
200
180
150
Pre-heating
Rising
5 °C/sec
0
Tm : Reflow machine setting temp (max 30 sec.)
Ts : Surface temp of PCB (max)
Ts : Surface temp of PCB (recommend)
Ts : Surface temp of PCB (min)
Cooling
-5 °C/sec
Time
[Hr]
2. Hand Soldering conditions
Lead : Not more than 3 seconds @MAX280℃
Slug : Use a thermal-adhesives
* Caution
1. Reflow soldering should not be done more than one time.
2. Repairing should not be done after the LEDs have been soldered. When
repairing is unavoidable, suitable tools have to be used.
3. Die slug is to be soldered.
4. When soldering, do not put stress on the LEDs during heating.
5. After soldering, do not warp the circuit board.
6. Recommend to use a convection type reflow machine with 7 ~ 8 zones.
Americas
147 Central Avenue
Hackensack, NJ 07601
[phone]
www.cml-it.com
Europe
Robert Bunsen Str. 1
D-67098 Bad Durkheim
[phone]
www.cml-it.com
12