CM5 Datasheet, PDF (2/4 Pages) Clare, Inc. – 4 Pin SOP OptoMOS Relay

Molded Ultra-Mini DYAD^™
CM5
Absolute Maximum Ratings (@ 25˚ C)
Parameter
Min Typ Max Units
Switching Voltage
CM5 - Molded Ultra Mini-DYAD^™
-
Switching Current
CM5 - Molded Ultra Mini-DYAD^™
-
Carry Current
CM5 - Molded Ultra Mini-DYAD^™
-
Switching Frequency
CM5 - Molded Ultra Mini-DYAD^™
-
Contact Resistance
CM5 - Molded Ultra Mini-DYAD^™
-
(See detailed specifications for more information.)
- 175 Volts
- 0.25 Amps
- 0.50 Amps
- 500 Hz
- 300 mΩ
Absolute Maximum Ratings are stress ratings. Stresses
in excess of these ratings can cause permanent damage
to the device. Functional operation of the device at these
or any other conditions beyond those indicated in the
operational sections of this data sheet is not implied.
Exposure of the device to the absolute maximum ratings
for extended period may degrade the device and effect
its reliability.
Specifications
All parameters are at 25°C unless otherwise stated.
PARAMETER
Contact Ratings
Operate ampere turns range
Release ampere turns range
5Switching Voltage
Switching Current
Carry Current
Contact Rating
Life Expectancy
Static Contact Resistance
Contact Material
Switch Specifications
Insulation Resistance⁽²⁾
Capacitance
Dielectric Strength⁽⁵⁾
Operate Time,
including bounce
Release Time
Environmental Ratings
Storage Temperature
Operating Temperature
Soldering Temperature
Vibration
Shock
Shock - survivability
CONDITIONS
SYMBOL MIN
Full Blade Tolerance = ± 1.5NI
AT
10
Full Blade Tolerance = ± 1.5NI
AT
5
Max DC/PeakAC Resistive
V
-
L
Max DC/PeakAC Resistive
I
-
L
Max DC/PeakAC Resistive
I_C
-
Max DC/PeakAC Resistive
-
-
1V, 10mA Signal Level
-
-
10V, 10mA Low Level
-
-
50V, 100mA Telecom Load
-
-
100V, 100mA Rated Loads
-
-
50mV, 10mA⁽¹⁾
CR
-
-
-
100V, 25°C, 40% RH
IR
10⁹
Across Open Contacts
-
-
Between Contacts
-
200
At nominal coil voltage,
T_OP
-
10Hz Square Wave
Zener-Diode Suppression⁽³⁾
T_REL
-
5Hz - 200Hz
11±1ms,
1/
2
Sine
Wave
11±1ms,
1/
2
Sine
Wave
T_A
-40
T_O
-40
-
-
G
-
S
-
S
-
TYP
-
-
-
-
-
-
1000
500
2
2
120
Ru
10¹¹
0.3
-
-
-
-
-
-
-
-
-
MAX
UNITS
30
NI
30
NI
175
VDC
250
mAmps
0.5
Amps
5
VA
-
x10⁶ Ops
-
-x10⁶ Ops
-
x10⁶ Ops
-
x10⁶ Ops
300
Ω
-
-
-
Ω
-
pF
- VDC/Peak AC
0.4
ms
0.1
ms
+125
˚C
+125
˚C
+265
˚C
20
-Gs
30
Gs
500
Gs
(1) _{Contact resistance measured with 4 terminal method, 1.1" between test leads}
(2) _>1012 _{Ω is available upon request}
(3) _{A 24V zener in series with a diode across the coil}
(4) _{Use caution not to exceed vibration resistance limits while ultrasonically cleaning. Contact Clare, Inc.}
Engineering for more details/ recommendations
(5) _{15 ampere turn minimum}
2
www.clare.com
Rev. 1