CLL Datasheet, PDF (3/4 Pages) Clairex Technologies, Inc – Photo-IC Sensors Digital Output

CLL Series
Photo-IC Sensors
Digital Output
® _Clairex
Technologies, Inc.
Absolute maximum ratings (T_A = 25°C unless otherwise stated)
storage temperature ........................................................................................................ -65°C to +150°C
operating temperature ..................................................................................................... -65°C to +125°C
lead soldering temperature⁽¹⁾............................................................................................................260°C
V_CC supply voltage...................................................................................................................4.5V to 18V
V_ADJ (CLL130-CLL133 and CLL130W-CLL133W only) ......................................................................... 3V
V_OUT (10kΩ pull-up series)⁽²⁾ ................................................................................................................ 18V
V_OUT (open collector series)⁽²⁾.............................................................................................................. 30V
I_SINK(3) ................................................................................................................................................ 25mA
continuous power dissipation⁽⁴⁾ ..................................................................................................... 250mW
NOTES:
1. 1/16” from the case for 5 seconds maximum.
2. This rating applies when the output is in the OFF state only.
3. This rating applies when the output is in the ON state only.
4. Derate linearly 2.0mW/°C from 25°C free air to T_A = 125°C.
5. CLL130-CLL133 and CLL130W-CLL133W photo-IC sensors are tested with the ADJ lead open.
6. Light source is an AlGaAs IRED with peak wavelength at 850nm.
DEFINITIONS:
• E_e (+) is the minimum irradiance required to cause the output to change state.
• Buffer: Output is HIGH when input irradiance is >E_e (+).
• Inverter: Output is LOW when input irradiance is >E_e (+).
electrical characteristics (T_A = 25°C unless otherwise noted)
parameter
symbol min typ max units
test conditions
Operating supply voltage
Positive going threshold
irradiance⁽⁶⁾
Hysteresis ratio
Supply current
V_CC
4.5
-
0.005 -
E_e (+)
0.025 -
E_eT (+)
E_eT (-)
1.1
-
I_CC
-
-
18
0.05
0.25
V
mW/cm²
mW/cm²
4.5V ≤ V_CC ≤ 18V, ADJ open,
All non-suffix W parts.
All suffix W parts.
1.8
operate point/release point
12
mA
4.5V ≤ V_CC ≤ 18V, Ee = 0
or 0.5mW, ADJ open
Total acceptance angle
Θ_P
-
30
-
-
70
-
deg. All non-suffix W parts
deg. All suffix W parts
Gain threshold can be adjusted on the CLL130-CLL133 and CLL130W-CLL133W series by
placing a resistor between the ADJ and GND leads in accordance with the following table.
Decreasing the resistance causes the output to switch at a higher threshold level.
ADJ Resistor
open
10k
4.7k
2.2k
1k
Connected to GND
Normalized Threshold
1.00
2.00
2.75
3.75
5.00
7.25
Clairex reserves the right to make changes at any time to improve design and to provide the best possible product.
Page 3 of 4
Clairex Technologies, Inc.
Phone: [phone]
1301 East Plano Parkway
Fax: [phone]
Plano, Texas 75074-8524
www.clairex.com