CL-L103-MC3L2-C Datasheet, PDF (8/9 Pages) CITIZEN ELECTRONICS CO., LTD. – LED lamp

SPECIFICATIONS
8/9
Precautions
1. Avoid the application of any stress to the lens portion.
2. Avoid any contact by a sharp metal nail or other materials with the lens portion.
Resin portion
3. This product should be secured firmly by fastening an M3 screw on both sides of the product.
Please be careful not to apply any stress to the product during the clamping operation.
As the connection status could vary depending on materials of outer heat sink,
please check thoroughly.
Recommended installation screw pitch
Recommended torque : 0.6~0.8N-m
M3screw (Insulation)
Spring washer (≦φ6mm)
Plane washer (≦φ6mm)
Thermal conductive silicon grease
(Insulation paste)
Outer heat sink
4. Thermal conductive silicone grease should be applied to the whole rear surface so that this product
can dissipate heat as a whole. However, the use of insulating paste is strongly recommended in
order to avoid short circuit. This product could be bent during the clamping operation if heat
grease in sheet form is used. For this reason, it is recommended that grease in paste form is used.
In addition, sufficient insulation should be established between heat sink area of LED package and
surface of fixture. (*surface of fixture: exterior of instrument used for dielectric strength test
in Electrical Appliance and Material Safety Law.)
5. Handling of static electricity
- These products are sensitive to static electricity charge.
Please take measures to prevent any static electricity being produced such as the wearing of a
wristband or anti-static gloves when handling this product.
- All devices, equipment and machinery must be properly grounded. It is recommended that precautions
be taken against surge voltage to the equipment that mounts the LEDs.
- ESD sensitivity of this product is 1000V (HBM, based on JEITA ED-4701/304).
- When inspecting the final products in which LEDs were assembled, it is recommended to check
whether the assembled LEDs are damaged by static electricity or not.
- It is easy to find static-damaged LEDs by a light-on test.
<Light-on test criterion>
Condition
Judgmental criterion
I_F=Max.1mA
No-lighting in entire block making
up parallel circuit is unacceptable
L103 consists of three blocks.
- 2010/3/1
Mark Date
Issue of first edition
Description Appro.
Approved Checked Drawn
Symbol
Name
CITILED
CL-L103-MC3L2-C
Drawing No
CITIZEN ELECTRONICS CO.,LTD.
Ref.CE-P570 03/10