CDB5451A Datasheet, PDF (6/24 Pages) Cirrus Logic – Evaluation Board and Software

CDB5451A
Name
HDR1
HDR2
HDR3
HDR4
HDR5
HDR6
HDR7
HDR8
HDR9
HDR10
HDR11
HDR12
SW1
HDR13
HDR14
Function Description
Used to switch IIN3+ on the CS5451A between J2
and AGND.
Default Setting
IIN3+ Set to BNC J2
Default Jumpers
O O IIN3+
O O AGND
Used to switch VIN3- on the CS5451A between J3
and AGND.
VIN3- Set to BNC J3
O O VIN3-
O O AGND
Used to switch VIN3+ on the CS5451A between J1
and AGND.
VIN3- Set to BNC J1
Used to switch IIN3- on the CS5451A between J4
and AGND.
IIN3- Set to BNC J4
Used to switch VIN2- on the CS5451A between J6
and AGND.
VIN2- Set to BNC J6
O O VIN3+
O O AGND
O O IIN3-
O O AGND
O O VIN2-
O O AGND
Used to switch IIN2+ on the CS5451A between J7
and AGND.
IIN2+ Set to BNC J7
O O IIN2+
O O AGND
Used to switch IIN2- on the CS5451A between J5
and AGND.
IIN2+ Set to BNC J5
O O IIN2-
O O AGND
Used to switch VIN2+ on the CS5451A between J8
and AGND.
VIN2+ Set to BNC J8
O O VIN2+
O O AGND
Used to switch between external VA- and on-board
CS5451A charge-pump circuit, CPD
CPD active
A- _{O O}
CPD O O
Used to switch VIN1+ on the CS5451A between J9
and AGND.
VIN1+ Set to BNC J9
O O VIN1+
O O AGND
Used to switch IIN1- on the CS5451A between J12
and AGND.
IIN1- Set to BNC J12
O O IIN1-
O O AGND
Used to switch IIN1+ on the CS5451A between J10
and AGND.
IIN1- Set to BNC J10
O O IIN1+
O O AGND
S1-1 sets logic level on CS5451A OWRS input pin _{SW1-2 Open (XIN/1024)}
S1-2 sets logic level on CS5451A GAIN input pin ^{SW1-1 Open (GAIN=x1)}
Used to switch VIN1- on the CS5451A between J11
and AGND.
VIN1- Set to BNC J11
Used to switch the VREFIN from external VREF
post connector, to the on board LT1004 reference,
or to the on-chip reference VREFOUT. Refer to
Table 3.
VREFIN Set to on-
chip reference
VREFOUT
Table 2. Default Header Settings
2
3
OPEN
O O VIN1-
O O AGND
O O LT1004
O O VREFOUT
O O EXT VREF
6
DS458DB3