CS8406 Datasheet, PDF (24/43 Pages) Cirrus Logic – 192 KHZ DIGITAL AUDIO INTERFACE TRANSMITTER

CS8406
8.2 Control 2 (02h)
7
6
5
4
3
2
1
0
0
0
0
0
0
MMT
MMTCS
MMTLR
MMT - Select AES3 transmitter mono or stereo operation
Default = ‘0’
0 - Normal stereo operation
1 - Output either left or right channel inputs into consecutive subframe outputs (mono
mode, left or right is determined by MMTLR bit)
MMTCS - Select A or B channel status data to transmit in mono mode
Default = ‘0’
0 - Use channel A CS data for the A subframe and use channel B CS data for the B subframe
1 - Use the same CS data for both the A and B subframe outputs. If MMTLR = 0, use the
left channel CS data. If MMTLR = 1, use the right channel CS data.
MMTLR - Channel Selection for AES Transmitter mono mode
Default = ‘0’
0 - Use left channel input data for consecutive subframe outputs
1- Use right channel input data for consecutive subframe outputs
8.3 Data Flow Control (03h)
7
6
5
4
3
2
1
0
0
TXOFF
AESBP
0
0
0
0
0
The Data Flow Control register configures the flow of audio data. The output data should be muted prior to changing
bits in this register to avoid transients.
TXOFF - AES3 Transmitter Output Driver Control
Default = ‘0
0 - AES3 transmitter output pin drivers normal operation
1 - AES3 transmitter output pin drivers drive to 0 V.
AESBP - AES3 bypass mode selection
Default = ‘0’
0 - Normal operation
1 - Connect the AES3 transmitter driver input directly to the RXP pin, which becomes a normal TTL
threshold digital input.
24
DS580F1