MB2F Datasheet, PDF (1/2 Pages) Microdiode Electronics (Jiangsu) Co.,Ltd. – SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIERS

MB2F THRU MB10F
SINGLE PHASE1.0AMPS. GLASS PASSIVATED BRIDGE RECTIFIERS
FEATURE
.Glass passivated junction.
.Ideal for printed circuit board.
.Reliable low cost construction utilizing
molded plastic technique.
.High surge current capability.
.High temperature soldering guaranteed:
260℃/10 seconds at terminals.
MECHANICAL DATA
MBF
.012(0.3)
.008(0.2)
+ ^{.276(7.0)M AX}
-
.165(4.2)
.150(3.8)
.036(0.9)
.020(0.5)
.106(2.7)
.091(2.3)
.043(1.1)
.020(0.5)
.Case Material: “Green” Molding compound,
UL flammability classification rating 94V-0,
.193(4.9)
.177(4.5)
.059(1.5)
.051(1.3)
“Free halogen”
.Moisture sensitivity level:level 2a,per J-STD-020
.Polarity:Polarity as marked on the body
.Weight: 0.105g (approximately)
.031(0.8)
.016(0.4)
.008(0.2)M AX
+
Dimensions in inches and (millimeters)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25℃ ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz,resistive or inductive load.
For capacitive load, derate current by 20%
Type Number
SYM
BOL
MB2F
MB4F
MB6F
MB8F MB10F
-
units
Maximum Recurrent Peak Reverse Voltage
VRRM
200
400
600
800
1000
V
Maximum RMS Voltage
VRMS
140
280
420
560
700
V
Maximum DC blocking Voltage
VDC
200
400
600
800
1000
V
Maximum Average Forward rectified Current
@ TA=40℃
IF(AV)
1.0
A
Peak Forward Surge Current 8.3ms single half
sine-wave superimposed on rate load (JEDEC I_FSM
30
A
method)
Maximum Instantaneous
Forward Voltage
@ IF =1.0A DC
@ IF = 0.5A DC
VF
1.1
0.95
V
Maximum DC Reverse Current @TJ =25°C
at rated DC blocking voltage @TJ =125°C
IR
I²t Rating for Fusing (t﹤8.3ms)
I²t
5.0
100.0
3.74
μA
A²Sec
Typical Junction Capacitance Per Leg (Note1)
Typical Thermal Resistance (Note2)
Storage Temperature
Operating Junction Temperature
CJ
RJC
RJA
TSTG
TJ
13
25
85
-55 to +150
-55 to +150
pF
°C /W
°C
°C
Note:
1. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc
2. Thermal resistance junction to case, lead and ambient in accordance with JESD-51.
Unit mounted on glass-epoxy substrate with 1oz/ft2_10x10 mm copper pad per pin with heatsink
1