DRP10_15 Datasheet, PDF (2/2 Pages) Chinfa Electronics Ind. Co., Ltd. – 10A REDUNDANT MODULE

DRP10 SERIES
MECHANISM & PIN CONFIGURATION
mm [inch]
1 2 345 6
A+ B+ -
+++ - - -
7 8 9 10 11 12
91.00 [3.58]
45.00 [1.77]
CONSTRUCTION
Easy snap-on mounting onto the DIN-Rail
(TS35/7.5 or TS35/15), unit sits safeIy and
firmly on the rail.
INSTALLATION
Ventilation / Cooling
Normal convection
All sides 25mm free space
For cooling recommended
Connector size range
AWG24-12 (0.2~2.5mm² ) flexible / solid cable,
connector can withstand torque at maximum
6 pound-inches.
7 m/m stripping at cable end recommends
Use copper conductors only, 60 / 75^oC
GENERAL TOLERANCE
0.00[0.00] - 30.00[1.18]
±0.30[0.01]
30.00[1.18] - 120.00[4.72]
±0.50[0.02]
PIN ASSIGNMENT
PIN NO.
Designation
1, 2
A+
3, 4
B+
5, 6
-
7, 8, 9
+
10, 11, 12
-
Description
Input terminal
Positive output terminal
Negative output terminal / input terminal
TYPICAL APPLICATION NOTES
1.) 1+1 Redundancy : Using 1 more PS as the redundant unit.
2.) Single Use : Connecting only one PS to one DRP10 to reduce
the stress of the diodes and hence increase the reliability.
PS#1
PS#2
DRP10
Vout
Load
PS#1
PS#1
Vin A
Vout
Vin B
DRP10
Vin A
Vout
Vin B
DRP10
Load
3.) 1+N Redundancy : Using 1 more PS as the redundant units to increase the reliability.
PS#1
PS#2
PS#1
PS#2
Vin A
Vout
Vin B
DRP10
Vin A
Vout
Vin B
DRP10
Load
CIRCUIT SCHEMATIC
Vin A+
Vin B+
Vout+
PS#1
Vin A
Vout
PS#2
Vin B
DRP10
Vin -
www.chinfa.com
2015.05.12
Vout-
[e-mail]
P2