CS4161 Datasheet, PDF (1/4 Pages) Cherry Semiconductor Corporation – 85mA Dual H-Bridge Odometer Driver with Divide by Select and UVLO

CS4161
85mA Dual H-Bridge Odometer Driver
with Divide by Select and UVLO
Description
The CS4161 is a Stepper Motor
Driver that implements an H-Bridge
design in order to drive two coils in
an eight step sequence per revolu-
tion in the divide by 1 mode; 16 step
sequence in the divide by 2 mode.
The H-Bridge is capable of deliver-
ing 85mA to the load.
The sequencer insures that the
odometer is monotonic. This
sequencer is configured such that
simultaneous conduction does not
occur. Before each successive out-
put sequence the part is taken
through a state where both outputs
are turned off individually. This
tends to minimize the inductive
kick back energy that the part must
absorb. On chip clamp diodes are
across each output to protect the
part from the kick back energy that
it must absorb.
The CS4161 includes overvoltage
and short circuit protection circuit-
ry. It is lead for lead compatible
with the CS-8441. The CS4161
includes an additional undervoltage
lockout (UVLO) function which dis-
ables the output stage until the sup-
ply voltage rises above 5.6V, typi-
cally. The UVLO has hysteresis to
prevent any power up glitching.
Features
s Undervoltage Lockout
s Cross-conduction
Prevention Logic
s Divide by 1 and Divide
by 2 Modes
s Guaranteed Monotonic
s On Chip Flyback Diodes
s Fault Protection
Overvoltage
Load Dump Protection
to 60V
Absolute Maximum Ratings
Supply Voltage (V_CC) (continuous) -40ûC to +105ûC .......................-0.5 to 24V
(100ms pulse transient) -40ûC to +105ûC...........................-0.5 to 60V
Input Voltage (V_IN) ...................................................................-0.3 to V_CC +0.3V
Operating Temperature Range ....................................................-40¡C to 105¡C
Storage Temperature Range (TSTG) ...........................................-65¡C to 150¡C
Junction Temperature Range .......................................................-40¡C to 150¡C
ESD (Human Body Model) .............................................................................2kV
Lead Temperature Soldering
Wave Solder (through hole styles only)............10 sec. max, 260¡C peak
Package Option
8 Lead PDIP
VCC
SENSOR
Input
Comp.
Block Diagram
Coil
Driver
A
COILA+
COILA-
Gnd 1
COILA+
COILAÐ
SENSOR
V_CC
COILB+
COILBÐ
SELECT
SELECT
¸1
¸2
Gnd
Rev. 1/28/97
Sequencer
Overvoltage
and Short
Circuit
Protection
Coil
Driver
B
COILB+
COILB-
1
Cherry Semiconductor Corporation
2000 South County Trail, East Greenwich, RI 02818
Tel: [phone] Fax: [phone]
Email: [e-mail]
Web Site: www.cherry-semi.com
A
¨ Company