S1A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SURFACE MOUNT RECTIFIER(VOLTAGE - 50 to 1000 Volts CURRENT - 1.0 Ampere)

S1A thru S1M SERIES
SURFACE MOUNT RECTIFIER
CHENG- YI
ELECTRONIC
VOLTAGE RANGE 50 TO 1000 Volts
CURRENT 1.0 Amperes
FEATURES
For surface mounted applications
High tempreature metallurgically bonded-no
compression contacts as found in other
diode-constructed rectifiers
Glass passivated junction
Built-in strain relief
Easy pick and place
Plastic package has Underwrites Laboratory
Flamability Classification 94V-O
Complete device submersible temperature of
260⁰C for 10 seconds solder bath
MECHANICAL DATA
Case:JEDEC DO-214AA molded plastic
Terminals:Solder plated solderable per
MIL-STD-750, Method 2026
Polarity:Indicated by cathode band
Standard Packaging: 12mm tape (EIA STD EIA-481)
Weight:0.003 ounce, 0.093 gram
SMB/DO-214AA
.075(1.91)
.083(2.11)
.083(2.13)
.096(2.44)
.030(0.76)
.050(1.27)
.160(4.06)
.185(4.70)
.130(3.30)
.155(3.94)
.006(.152)
.012(.305)
.004(.102)
.008(.203)
.200(5.08)
.220(5.59)
Dimensions in inches and (millimeters)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25⁰C ambient temperature unless otherwise specified.
Signle phase, half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
RATINGS
SYMBOL S1A S1B S1D S1G S1J S1K S1M UNITS
Maximum Recurrent Peak Reverse Voltage
VRRM
50
100 200 400 600 800 1000 Volts
Maximum RMS Voltage
VRMS
35
70
140 280 420 560 700
Volts
Maximum DC Blocking Voltage
VDC
50
100 200 400 600 800 1000 Volts
Maximum Average Forward Rectified Current, at TL=100⁰C
I(AV)
1.0
Amps
Peak Forward Surge Current 8.3 ms single half sine-wave
superimposed on rated load (JEDEC method)
IFSM
30.0
Amps
Maximum Instantaneous Forward Voltage at 1.0A
VF
Maximum DC Reverse Current at Rated ^@TA=250C
DC Blocking Voltage
IR
@TA=125⁰C
Maximum Reverse Recovery Time (Note 1)
TRR
Typical Junction Capacitance (Note 2)
CJ
Maximum Thermal Resistance (Note 3)
R JL
Operating and Storage Temperature Range
TJ TSTG
Notes : 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, Irr=0.25A
2. Measured at 1 MHz and Applied Vr= 4.0 volts
3. 8.0mm²(0.13mm thick) land areas
1.10
5.0
200
2.5
15.0
30.0
-50 to +150
Volts
A
S
pF
0_{C / W}
0_C