P6SMBJ Datasheet, PDF (1/4 Pages) Pan Jit International Inc. – SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR(VOLTAGE - 5.0 to 220 Volts 600 Watt Peak Power Pulse)

P6SMBJ SERIES
SURFACE MOUNT TRANSIENT
VOLTAGE SUPPRESSOR
CHENG- YI
ELECTRONIC
VOLTAGE 5.0 to 170 VOLTS
PEAK PULSE POWER 600 WATTS
SMB/DO-214AA
FEATURES
For surface mounted applications in order to
optimize board space
Low profile package
Built-in strain relief
Glass passivated junction
Low inductance
Excellent clamping capability
Repetition Rate (duty cycle):0.01%
Fast response time: typically less then 1.0 ps
from 0 volts to BV for unidirectional types
Typical ID less then 1 A above 10V
High tempreature soldering:260⁰C/10 seconds
at terminals
Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
.075(1.91)
.083(2.11)
.083(2.13)
.096(2.44)
.030(0.76)
.050(1.27)
.160(4.06)
.185(4.70)
.130(3.30)
.155(3.94)
.006(.152)
.012(.305)
.004(.102)
.008(.203) _.200(5.08)
.220(5.59)
Dimensions in inches and (millimeters)
MECHANICAL DATA
Case:JEDEC DO-214AA molded plastic over passivated junction
Terminals:Solder plated solderable per MIL-STD-750, Method 2026
Polarity:Color band denotes positive end (cathode) except Bidirectional
Standard Packaging: 12mm tape (EIA STD EIA-481-1)
Weight:0.003 ounce, 0.093 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25⁰C ambient temperature unless otherwise specified.
RATINGS
Peak Pulse Power Dissipation on 10/1000 s (NOTE 1,2,Fig.1)
Peak Pulse on Current 10/1000 s waveform (NOTE 1,Fig.3)
Peak forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method)(NOTE 2,3)
Operating Junction and Storage Temperature Range
SYMBOL
PPPM
IPPM
IFSM
TJ, TSTG
VALUE
Minimum 600
See Table 1
100.0
-55 to + 150
UNITS
Watts
Amps
Amps
0_C
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above TA=25⁰C per Fig.2
2. Measured on 5.0mm2 (0.13mm thick) land areas
3. Measured on 8.3mm, single half sine-wave or equivalent square wave, duty cycle=4 pulses per minute maximum.
265