RABS2 Datasheet, PDF (1/2 Pages) DIYI Electronic Technology Co., Ltd. – Low forward voltage drop

RABS2 THRU RABS10
GLASS PASSIVATED FAST RECOVERY BRIDGE RECTIFIERS
Voltage Range - 200 to 1000 Volts Current - 0.8/1.0 Ampere
ABS
FEATURES
Ideal for printed circuit board
Reliable low cost construction utilizing
molded plastic technique
High temperature soldering guaranteed:
260 /10 seconds at 5 lbs., (2.3kg) tension
Small size, simple installation
Leads solderable per MIL-STD-202,
Method 208
High surge current capability
Glass passivated chip junction
Green compound(halogen&Sb2O3 free)
Dimensions in inches and (millimeters)
MECHANICAL DATA
Case: Molded plastic body
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Polarity: Polarity symbols marked on case
Mounting Position: Any
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified.
Single phase half-wave 60Hz,resistive or inductive load, for capacitive load derate current by 20%.
MDD Catalog Number
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current
On glass-epoxy P.C.B.(Note1)
On aluminum substrate(Note2)
Peak forward surge current,
8.3ms single half sine-wave superimposed on
rated load
Maximum instantaneous forward voltage drop
per leg at 0.4A
Maximum DC reverse current TA=25
at rated DC blocking voltage TA=125
Typical thermal resistance(NOTE 3)
SYMBOLS
VRRM
VRMS
VDC
RABS2
200
140
200
RABS4
400
280
400
RABS6
600
420
600
RABS8
800
560
800
RABS10 UNITS
1000
V
700
V
1000
V
IF(AV)
0.8
A
1.0
IFSM
30
A
VF
1.3
V
IR
5.0
uA
500
uA
R JL
25
R JA
75
/W
Maximum reverse recovery time (NOTE 4)
trr
150
250
500
ns
Operating temperature range
TJ
-55 to +150
storage temperature range
TSTG
-55 to +150
NOTES:1.On glass epoxy P.C.B. mounted on 0.05x0.05''(1.3x1.3mm) pads.
2.On aluminum substrate P.C.B. with an area of 0.8''x0.8''(20x20mm) mounted on 0.05X0.05''(1.3X1.3mm) solder pad.
3.Thermal resistance form junction to ambient and junction to lead mounted on P.C.B. with 0.2X0.2''(5X5mm) copper pads.
4.Reverse recovery condition IF=0.5A,IR=1.0A,Irr=0.25A.