MB2M Datasheet, PDF (1/2 Pages) General Semiconductor – MINIATURE GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER

MB2M THRU MB10M
SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIERS
Voltage Range - 200 to 1000 Volts Current - 0.5/0.8 Ampere
MBM
~~
+^-
C0.5
.051(1.3)
.035(0.9)
.031(0.8)
.019(0.5)
.106(2.7)
.090(2.3)
.193(4.9)
.177(4.5)
.106(2.7)
.090(2.3)
.217(5.5)
.177(4.5)
.031(0.8)
.019(0.5)
.165(4.2)
.146(3.7)
.014(.35)
.006(.15)
.256(6.5)
.217(5.5)
.106(2.7)
.090(2.3)
Dimensions in inches and (millimeters)
FEATURES
Ideal for printed circuit board
Reliable low cost construction utilizing
molded plastic technique
High temperature soldering guaranteed:
260 /10 seconds at 5 lbs., (2.3kg) tension
Small size, simple installation
High surge current capability
MECHANICAL DATA
Case: Molded plastic body
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Polarity: Polarity symbols marked on case
Mounting Position: Any
Weight:0.0044 ounce, 0.125 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified.
Single phase half-wave 60Hz,resistive or inductive load, for capacitive load derate current by 20%.
MDD Catalog Number
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current
at TC=30 On glass-epoxy P.C.B.
On aluminum substrate
Peak forward surge current,
8.3ms single half sine-wave superimposed on
rated load (JEDEC Method)
Maximum instantaneous forward voltage drop
per leg at 0.4A
Maximum DC reverse current TA=25
at rated DC blocking voltage TA=125
Typical junction capactiance per leg(Note3)
Typical thermal resistance per leg
Operating temperature range
storage temperature range
SYMBOLS
VRRM
VRMS
VDC
MDD
MB2M
200
140
200
MDD
MB4M
400
280
400
IF(AV)
MDD
MB6M
600
420
600
0.5
0.8
IFSM
30
MDD
MB8M
800
560
800
MDD
MB10M
1000
700
1000
UNITS
VOLTS
VOLTS
VOLTS
Amps
Amps
VF
IR
CJ
R JA
TJ
TSTG
1.0
5.0
500
15
75
-55 to +150
-55 to +150
Volts
uA
uA
pF
/W
NOTES:1.On glass epoxy P.C.B. mounted on 0.05x0.05''(1.3x1.3mm) pads
2.On aluminum substrate P.C.B. with on area of 0.8''x0.8''(20x20mm) mounted on 0.05X0.05''(1.3X1.3mm) solder pad
3.Measured at 1.0MHz and applied reverse voltage of 4.0 volts.