EABS2 Datasheet, PDF (1/2 Pages) Microdiode Electronics (Jiangsu) Co.,Ltd. – 200 to 600Volts Current - 0.8/1.0 Ampere

EABS2 THRU EABS8
ABS
GLASS PASSIVATED SUPER FAST RECOVERY BRIDGE RECTIFIERS
Voltage Range - 200 to 600Volts Current - 0.8/1.0 Ampere
FEATURES
Ideal for printed circuit board
Reliable low cost construction utilizing
molded plastic technique
High temperature soldering guaranteed:
260 /10 seconds at 5 lbs., (2.3kg) tension
Small size, simple installation
Leads solderable per MIL-STD-202,Method 208
High surge current capability
Super fast switching for high efficiency
Glass passivated chip junction
Green compound(halogen&Sb2O3 free)
Dimensions in inches and (millimeters)
MECHANICAL DATA
Case: Molded plastic body
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Polarity: Polarity symbols marked on case
Mounting Position: Any
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified.
Single phase half-wave 60Hz,resistive or inductive load, for capacitive load derate current by 20%.
MDD Catalog Number
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward rectified current
On glass-epoxy P.C.B.(Note1)
On aluminum substrate(Note2)
Peak forward surge current,
8.3ms single half sine-wave superimposed on
rated load
Maximum instantaneous forward voltage drop
per leg at 0.4A
Maximum DC reverse current TA=25
at rated DC blocking voltage TA=125
Typical thermal resistance(NOTE 3)
SYMBOLS
VRRM
VRMS
VDC
IF(AV)
EABS2
100
70
100
IFSM
EABS4
200
140
200
EABS6
400
280
400
0.8
1.0
30
VF
IR
R JL
R JA
0.95
1.25
5.0
500
25
75
EABS8
600
420
600
UNITS
V
V
V
A
A
1.7
V
uA
uA
/W
Maximum reverse recovery time (NOTE 4)
trr
35
ns
Operating temperature range
TJ
storage temperature range
TSTG
-55 to +150
-55 to +150
NOTES:1.On glass epoxy P.C.B. mounted on 0.05x0.05''(1.3x1.3mm) pads.
2.On aluminum substrate P.C.B. with an area of 0.8''x0.8''(20x20mm) mounted on 0.05X0.05''(1.3X1.3mm) solder pad.
3.Thermal resistance form junction to ambient and junction to lead mounted on P.C.B. with 0.2X0.2''(5X5mm) copper pads.
4.Reverse recovery condition IF=0.5A,IR=1.0A,Irr=0.25A.