ECHA201VSN181MP20S Datasheet, PDF (1/2 Pages) United Chemi-Con, Inc. – LARGE CAPACITANCE ALUMINUM ELECTROLYTIC CAPACITORS

LARGE CAPACITANCE ALUMINUM ELECTROLYTIC CAPACITORS Overvoltage-proof design, 105C
@No sparks against DC over-voltage
@Downsized from current KLG series
@Endurance with ripple current : 105C, 2000hours
@Non solvent-proof type
@Pb-free design
LXH
downsized
longer life
KLG
downsized
CHA
?SPECIFICATIONS
Items
Characteristics
Category
Temperature Range ^{-25 to +105C}
Rated Voltage Range
Capacitance Tolerance
Leakage Current
Dissipation Factor
(tane)
Low Temperature
Characteristics
(Max.Impedance Ratio)
ESL
Endurance
Shelf Life
200 & 400Vdc
P20% (M)
(at 20C, 120Hz)
I=3 CV
Where, I : Max. leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (Vdc)
(at 20C after 5 minutes)
200Vdc : 0.15 max. (0.20 max. for FD=35mm)
400Vdc : 0.15 max.
(at 20C, 120Hz)
Rated Voltage (Vdc)
200V
400V
Z(-25C) / Z(+20C)
4
4
(at 120Hz)
50nH max.
(at 20C, 1MHz)
The following specifications shall be satisfied when the capacitors are restored to 20C after subjected to DC voltage with the rated
ripple current is applied for 2000 hours at 105C.
Capacitance change [P20% of the initial value
D.F. (tanE)
[200% of the initial specified value
Leakage current
[The initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20C after exposing them for 1000 hours at 105C
without voltage applied.
Capacitance change [P15% of the initial value
D.F. (tanE)
[150% of the initial specified value
Leakage current
[The initial specified value
?DIMENSIONS [mm]
@Terminal Code : VS (F22 to F35)
Sleeve (PET)
Negative mark
PC board pin-out
10
Vent
LP2
4.0P0.5
2-F2
No plastic disk is the standard design
?PART NUMBERING SYSTEM
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
E CHA AAA VS N AAA M AAA S
Supplement code
Size code
Capacitance tolerance code
Capacitance code (ex. 56MF:560,100MF:101)
Dummy terminal code
Terminal code
Voltage code (ex. 200V:201,400V:401)
Series code
Category
Please refer to "A guide to global code (snap-in type)"
?RATED RIPPLE CURRENT MULTIPLIERS
@Frequency Multipliers
Frequency (Hz) 50
120 300
1k
10k 50k
200 & 400Vdc 0.77 1.00 1.16 1.30 1.41 1.43
(1/2)
CAT. No. E1001E