|
APSK2R5E Datasheet, PDF (1/2 Pages) United Chemi-Con, Inc. – Radial Lead | |||
|
CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
New!
Radial Lead
ËSuper low ESR, high ripple current capability
ËDownsized from PSE series (Ð6.3Ê·8L to Ð5Ê·8L)
ËLonger life (5,000 hours at 105Ë)
ËESR after endurance is speciÃed within the initial spec
ËRoHS Compliant
ËHalogen Free
PSK
Downsized
PSE
ËSPECIFICATIONS
Items
Characteristics
Category
Temperature Range -55 to +105Ë
Rated Voltage Range
Capacitance Tolerance
Surge Voltage
Leakage Current*Note
Dissipation Factor
(tanÐ)
Low Temperature
Characteristics
(Max.Impedance Ratio)
Endurance
Bias Humidity Test
Surge Voltage Test
Failure Rate
2.5Vdc
ʶ20% (M)
Rated voltage(V)Ê·1.15
500Ñ¥A max.
(at 20Ë, 120Hz)
(at 105Ë)
(at 20Ë after 2 minutes)
0.10 max.
(at 20Ë, 120Hz)
Z(-25Ë)/Z(+20Ë)ʽ1.15
Z(-55Ë)/Z(+20Ë)ʽ1.25
(at 100kHz)
The following specifications shall be satisfied when the capacitors are restored to 20Ë after the rated voltage is applied for 5,000 hours
at 105Ë.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽThe initial specified value
Leakage current
ʽThe initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20Ë after subjecting them to DC voltage at 60Ë,
90 to 95% RH for 1,000 hours.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽThe initial specified value
Leakage current
ʽThe initial specified value
The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105Ë for 30 seconds
through a protective resistor(R=1kÐ) and discharge for 5 minutes 30 seconds.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽThe initial specified value
Leakage current
ʽThe initial specified value
0.5% per 1,000 hours maximum (Confidence level 60% at 105Ë)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105Ë.
ËDIMENSIONS [mm]
ËTerminal Code : E
Coated Case
L'
15min.
4min.
Size code
ÐD
Ðd
F
ÐD'
L'
E08
5.0
0.45
2.0
ÐD+0.5max.
L+1.0max.
ËMARKING
EX) 2.5V560Ñ¥F
K6D6
560
2.5V
Product speciï¬cations in this catalog are subject to change without notice.Request our product speciï¬cations before purchase and/or use. Please use our products based on the information contained in this catalog and product speciï¬cations.
(1/2)
CAT. No. E1001L
|
▷ |